732444
5
Zoom out
Zoom in
Previous page
1/9
Next page
3. Please ensure the ice cube maker is placed on a stable table or platform to avoid malfunction.
4. The incline angle of the ice cube maker cabinet should not exceed 45° during transportation or use. Do not
turn the ice cube maker upside down otherwise it could cause the compressor or refrigerating system to
operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice cube maker is
moved or transported. Before using the ice cube maker for the first time, please wait for 2 hours after the
unit has been moved and positioned in the proper place.
5. The ice cube maker must be placed on a dry and flat surface with sufficient ventilation, far from heat sources
such as ovens, heaters and corrosive gases. Leave about 15cm space on all sides of the ice cube maker for
proper ventilation.
6. Do not fill the water reservoir with hot water. This may damage the ice cube maker. It is best to fill the water
reservoir with water of room temperature or lower.
7. Do not use the appliance at a very cold environment (lower than 5).
8. Clean the appliance by following the operation of “CLEANING AND MAINTENANCE” before operate.
Using your ice cube maker
1. Ensure that the drain plug at the bottom of the water reservoir is closed well.
2. Plug the ice cube maker into the wall outlet, the “ICE” indicator blinks.
NOTE: please make the ice cube maker be rested for 30 minutes before pluged if it has been moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the “ON/OFF” key, and the “ICE”indicator lights solidly.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature and water
temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over
the next 7-15 minutes ice forms on the evaporator. Once this has completed, the ice tray will tilt backwards
and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then
dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and start the next cycle.
9. The “ICE FULLindicator will light up when the ice basket is full and then the ice cube maker will stop the
ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 5
seconds later, the ice cube maker will restart its ice making function automatically.
10. The ADD WATER” indicator will light up when the water reservoir is lack of water and the ice-making cycle
will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then
press the “ON/OFF” key again to restart the ice-making cycle. The appliance will start working automatically
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trebs 99363 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trebs 99363 in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info