798768

Traeger XL - BBQ150.01 Manual

19
Zoom out
Zoom in
Previous page
1/24
Next page
d) Disconnect Power Cord from electrical outlet and remove Pellets from the Pellet
Hopper. Check for foreign objects and wet/decomposed Pellets, both of which can
cause a jam in the Auger system. The Auger will need to be removed to clear a jam in
the Auger system. See “HOW DO I REMOVE THE AUGER IF IT JAMS?” section
below.
`HOW DO I REMOVE THE AUGER IF IT JAMS?
1) Remove any covers necessary to access the Auger Drive Motor.
2) Remove the screw connecting the Auger Drive Motor shaft to the Auger shaft and the
screw retaining the Auger Bushing into the Auger Tube.
3) With a small pipe wrench or locking pliers on the Auger shaft, turn the Auger counter
clockwise. It will turn hard until it breaks free, then the Auger will turn freely.
4) Remove the Auger and clean all Pellets, ash or foreign objects from the Auger, Auger Tube
and Firepot. A shop-vac is ideal tor this task.
5) Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the
Auger Tube and sand it if needed. Vacuum the sanding grit out of the Auger Tube and
Firepot when finished.
6) Reinstall the Auger Bushing and the Auger into the Auger Tube, making sure that the Auger
rotates freely.
7) Re-attach the Auger shaft to the Auger Drive Motor shaft.
WHY DOES MY GRILL FIRE GO OUT ON “SMOKE” SETTING?
Excess ash in the Firepot may be the problem.
1) Open the Door and remove the Porcelain Grill, Grease Drain Pan and Heat Baffle from
inside the Grill.
2) IMPORTANT: Remove all unburned Pellets and ash from inside and around the
Firepot. A shop-vac is ideal tor this task CAUTION! ASSURE THAT THE GRILL IS COLD
TO AVOID A FIRE FROM HOT ASH.
3) Replace the Heat Baffle, Grease Drain Pan and the Porcelain Grill and initiate start-up
procedure.
4) If this didn’t remedy the problem, contact Traeger Technical Support (SECTION SEVEN)
for additional troubleshooting help.
WITH THE TRAEGER DIGITAL CONTROL, WHAT DIAL SETTING IS RECOMMENDED
FOR STARTING THE GRILL?
The auto-start procedure is the same for all Grill Controls. With the Door open, turn the
Switch/Dial ON and Temperature Dial to SMOKE. In approximately 2 minutes you will
notice whitish-gray smoke coming out of the Grill as the Pellets ignite. After assuring the
Pellets have ignited, close the Door and set the Temperature Dial to any cooking setting
desired.
HOW DO I PROTECT MY PAINT FINISH?
1) Use a protective Cover on the Grill and touch-up paint to repair any scratches. A
TRAEGER GRILL COVER to protect the Grill is highly recommended! Covers and
touch-up paint are available from your Traeger Dealer, or log on to our Web Site –
www.traegergrills.com.
2) Every 90 days, use a high quality car wax on the outside surfaces of the Grill. ONLY
APPLY WAX TO A COLD GRILL.
WHERE CAN I GET A NEW PART FOR MY GRILL?
Check with your Traeger Dealer. They may have the part in stock or can order the part for you.
Or you can contact the Traeger Parts Department (SECTION SEVEN) to place an order. In
either case, please provide your name, phone number, address, Model and Serial Number of
the Grill (located on a label inside the Hopper Lid), along with the part identification.
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger XL - BBQ150.01 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger XL - BBQ150.01 in the language / languages: English as an attachment in your email.

The manual is 1.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info