798690
7
Zoom out
Zoom in
Previous page
1/18
Next page
3) Remove the Porcelain Grills, Grease Drain Pan and Heat Baffle to expose the Firepot
In the bottom of the Grill.
4) Pour 1/2 cup of TRAEGER BBQ PELLETS into the Firepot.
5) Squirt 2 tablespoons of Alcohol Gel fire lighter into the Firepot on top of the Pellets.
DANGER! Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter
fluid or similar liquids to start or “freshen up” a fire in this Grill. Keep all such liquids
well away from the Grill when in use.
6) Carefully light the Alcohol Gel with a fireplace match or a long-reach butane lighter.
DANGER! Never squirt Alcohol Gel into a burning fire or a hot Firepot. The Alcohol
Gel bottle could explode and cause a fire, serious injury or death.
7) Let the Alcohol Gel and Pellets burn for approximately 4 minutes.
8) After assuring the Pellets have ignited, install the Heat Baffle, Grease Drain Pan and
Porcelain Grills back in place.
CAUTION! You will now have a fire in the Firepot. Be careful not to burn yourself
when you install these components. Gloves are recommended.
9) Turn the Switch ON (--) and the Temperature/Dial to any setting desired. With the
Door closed, let the Grill pre-heat for approximately 10 minutes before placing food in
the Grill.
Control Shutdown cycle
The control for this barbecue comes with an automatic shut down cycle. When
finished cooking on your barbecue set the Temperature/Dial Knob to the Shutdown
Cycle position, this will leave the Draft Induction Fan running for ten minutes to burn any
excess pellets in the fire pot. After the fan runs for ten minutes the controller will power
off and the fan and it will stop running. CAUTION! The main power switch will shut the
power off to the controller and the Temperature/Dial Knob switch will cut off power to
the grill components only. When servicing the controller or any parts ensure that the
power supply is disconnected to avoid a shock hazard.
Control Safety Features
The controller comes equipped with 2 safety features that will help you to keep
the grill operating correctly. The first of these is a low temperature alarm. If the grill
stays below 125 degrees as read by the RTD temperature sensing device for a period
of 10 minutes the control will go into an alarm state and the display will read “LEr”. This
will shut off all power to the internal components of the grill. The display will stay in this
state until you turn off the main power switch.
The second safety feature will be a high temperature alarm. If the grill obtains an
internal temperature reading of 550 degrees as read by the RTD temperature sensing
device the control will go into alarm state and the display will read “HEr”. This will turn
off all power to the internal components of the grill. The display will stay in this state until
you turn off the main power switch.
Whenever either of these alarm conditions occurs you should check to see what
caused this condition and fix the problem. Call customer service if you need help.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger Select Pro - BBQ400.03 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger Select Pro - BBQ400.03 in the language / languages: English as an attachment in your email.

The manual is 1.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info