798654

Traeger Ironwood 885 - Gen 1 Manual

20
Zoom out
Zoom in
Previous page
1/28
Next page
20
OPERATING TIPS (cont.)
TROUBLESHOOTING
8. GREASE MANAGEMENT:
CAUTION! Grease res are caused by not
properly maintaining the grill and failing to
clean the Traeger Grease Management System
(TGMS) on a consistent basis (see “Maintaining
Your Grill”). In the unlikely event of a grease
re while cooking, turn the grill off and keep
the door closed until the re is completely out.
Never keep the door open during a grease re.
If the re does not go out, lightly sprinkle
baking soda on the re.
CAUTION! Be careful not to burn yourself. If
this does not work, carefully remove the food
from the grill and keep the door closed until the
re is completely out. Again, be careful not to
burn yourself. When the grill is completely cool,
remove all internal components. Clean any grease
accumulation from the TGMS. Replace the grease
drip tray and grill grates, restart the grill, and
resume cooking.
Although rare, you may see an error message display on your control panel. Please refer to the following chart
for potential issues and how to resolve them:
CODE ERROR SOLUTION
LEr Low temperature This will occur if the temperature of the grill falls below 120°F for 10 minutes,
causing the grill to go into shutdown mode. To x, remove any pellets from the
repot. Turn the controller off and then on again and restart your grill. If the
problem persists, call customer service.
HEr High temperature This error will occur when the temperature in the grill reaches temperatures
above 550°F for more than 45 seconds. Let the grill cool, then turn off the
grill. Clear out any remaining pellets from the repot and restart your grill.
If the problem persists, call customer service.
Er1 Bad probe Your probe will need to be replaced.
Er2 Thermocouple
disconnected
Check the connection underneath the hopper for the thermocouple. If it is
tight, your thermocouple will need to be replaced.
Er3 Failed to ignite Check the connection of the hot rod. If the connection is good, then the hot
rod will most likely need to be replaced
Er4 Fan disconnected Check the connection of the fan. If the connection is good, then the fan will
most likely need to be replaced.
Er5 Igniter disconnected Check the connection of the hot rod. If the connection is good, then the hot
rod will most likely need to be replaced.
Er6 Auger disconnected Check the connection for the auger. If the connection is good, then auger
motor will most likely need to be replaced.
Er7 Auger jammed With the grill in Idle mode, press and hold the DOWN and IGNITE buttons at
the same time. The display will ash “Clr,” and for the next 60 seconds, the
auger will cycle between moving forwards and backwards to clear the jam.
To stop the sequence before it is complete, press and hold the DOWN and
IGNITE buttons at the same time.
3883 Ironwood_UCG updatev02.indd 20 12/19/17 2:50 PM
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger Ironwood 885 - Gen 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger Ironwood 885 - Gen 1 in the language / languages: English as an attachment in your email.

The manual is 9.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info