485654
12
Zoom out
Zoom in
Previous page
1/42
Next page
22
23
Preparations
Names of the connector panel terminals
(11)(12)(13)(14)(15)(16)(19) (18)(17)
(8)(6) (7)(5)(4)(3) (10)(9)(2)(1)
Name : Main Function
(1) COMPUTER 1 IN : Connect a VGA cable from a computer.
(2) LAN : Connect a LAN cable from a computer.
(3) USB :
Connect the USB cable from a computer for rmware
upgrades or keypad remote emulation.
(4) AUDIO IN (1) : Connect the audio cable from the input device.
(5) COMPUTER 3 IN :
Connect the DVI cable from a computer.
(6) AUDIO IN (3) : Connect the audio cable from the input device.
(7)
AUDIO OUT
: Audio loop through.
(8) MONITOR OUT : Connect a monitor.
(9)
AUDIO IN (2)
: Connect the audio cable from the input device.
(
10
) RS232C terminal :
When operating the projector via a computer, connect this
to the controlling computer’s RS-232C port
.
p.79
(
11
) SCREEN TRIGGER : When connected to the screen through a commercially
available cable, the screen deploys automatically on
start up of the projector. The screen retracts when the
projector is powered off.
p.80
(
12
) Main power switch : Turn on/off the projector.
(
13
) S-VIDEO : Connect a commercially available S-video cable from a video
device.
(
14
) L/MONO, R
(Component)
: Connect an RCA audio cables from the input device right and
left channels.
(
15
) AC IN : Connect the supplied power cable.
(
16
) L/MONO, R (Video) : Connect RCA audio cables from the input device right and
left channels.
This audio jack is shared with S-Video input.
(
17
) VIDEO IN : Connect a composite video cable from a video device to the
yellow RCA jack.
(
18
) COMPONENT IN
(Y, Cb/Pb, Cr/Pr)
: Connect a component video enabled device.
(
19
) COMPUTER 2 IN
(R/PR, G/Y, B/PB, H, V)
: Connect RGBHV or Component signal from computer or
component video enabled device.
Loading dry-cell
batteries
into the remote control
1
Remove the battery cover.
2
Insert the dry-cell batteries.
Be sure to align the plus and minus ends of
the batteries properly.
Two batteries (LR03, SIZE AAA) are used.
3
Replace the battery cover.
Operating the remote
control
Point toward the projector’s infrared
remote sensor, and press a button
on the remote control.
Operating the projector from the front
Approx. 15°
Approx. 7m
Note
The above operation is also applicable
for the remote control operation from
rear side.
Dry-cell batteries
Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
If the remote control stops working, or if its range decreases, replace all the batteries with new
ones. (2 batteries (LR03 SIZE AAA))
Do not heat, take apart, or throw batteries into re.
Do not use new and old batteries together, or different types of batteries together.
Dispose of used batteries according to local regulations.
Remove batteries from remote control when not using for extended periods.
Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are
swallowed, seek medical assistance immediately.
The remote control
Avoid exposing the remote control infrared sensor to bright sunlight or uorescent lighting.
Do not drop or bang.
Do not leave in hot or humid locations.
Do not allow it to get wet or place it on top of wet objects.
Do not take it apart.
Ensure that the battery polarities (+/–) are aligned correctly.
In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
Preparing and using the remote control
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba TDP-WX5400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba TDP-WX5400 in the language / languages: English as an attachment in your email.

The manual is 7,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info