215054
20
Zoom out
Zoom in
Previous page
1/36
Next page
Using the projector and remote control 20
Using the projector and remote control
Preparations
Turning the power on
Follow the steps below.
1. Make sure the Power light is orange after power has been applied
and the main AC power switch is turned on.
2. Press and hold the ON/STANDBY button on the projector or
remote control to turn the projector on.
The ON/STANDBY button may not work while the projector is warming up.
3. The fans will be running. A start-up image shows on-screen for a
few seconds.
4. "Searching…." will display on-screen before the projector
identifies the input signal. This message will remain on-screen
until a valid signal is detected.
5. If the horizontal frequency of the input signal exceeds the range of the projector, a message
reading "Unsupported timing" will display on-screen. This message will remain on-screen until
you change the input signal.
Switching input signals
The projector can be connected to multiple devices at the same time.
To sequentially select input signals, press one of the INPUT buttons on
the remote control or INPUT on the projector.
Q When the projector is turned on, it will search for the input source
you last selected.
Q If you need to use the PIP or POP function, refer to for
advanced operation.
1. Turn on all connected devices.
2. Remove the lens cap.
3. Plug the supplied power cord into the AC inlet on
the rear of the projector and turn the main AC
power switch on.
4. Plug the power cord into a power outlet.
p.23
CAUTION
• Do not look into the lens while the lamp is on. The strong light from
the lamp may cause damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire
due to internal overheating.
• Do not place your hands, face, or other objects near the air
exhaust. Doing so could cause burns, deform/break the object.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba mt700 dlp projector 720p at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba mt700 dlp projector 720p in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info