807535
77
Zoom out
Zoom in
Previous page
1/92
Next page
77
DE EN
8.3.1 Starting hydrogeneration
1. Switch on the Torqeedo system.
2. Set the accelerator lever to the neutral position.
3. Place the emergency stop magnetic chip or connect the kill switch line to
the switch, make sure the emergency stop magnetic chip or kills witch cord
is connected to the skipper.
4. Travel at a speed of at least 4 knots (travel through water, STW).
5. Set the accelerator lever in forward drive to the range 1 - 30 %.
»Hydrogeneration is started.
»“Charging” appears in the display.
»The battery is being charged.
»The charging power generated is shown in the accelerator lever display.
8.3.2 Switching off hydrogeneration
Automatic switch off
Hydrogeneration is automatically switched off when
the speed over ground (SOG) is below 4 kn for more than 30 seconds or no
positive power is produced.
the speed over ground (SOG) is above 14 knots for more than 30 seconds.
the state of charge (SOC) of the battery has reached 100%.
»The “Charging” indicator in the display goes out.
NOTE! Hydrogeneration does not start automatically after switching off. Start
hydrogeneration manually again if necessary.
Manual switch off
1. Set the accelerator lever to the neutral position.
»Hydrogeneration is ended.
»The “Charging” indicator in the display goes out.
8.4 Charging
The charging process of your Torqeedo system differs depending on the
conguration and components used.
The corresponding information can be found in the operating manual for the
respective charger unit.
NOTE! Only use Torqeedo charger units for Torqeedo batteries.
NOTE! To charge the batteries in the boat, a land connection in the boat with
galvanic isolator is required according to applicable national requirements (e.g.
DIN EN ISO 13297, ABYC E-11).
NOTE! Never use mains power cables coiled up to avoid overheating of the
cables.
8.4.1 Charging with Power 24 batteries
Charging
1. Switch on the batteries or the system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. “Charging” is shown in the display.
5. Fully charge the batteries.
Ending charging
1. Unplug the charger unit.
2. Switch off the system or the battery.
8.4.2 Charging with Power 48 batteries
Charging
1. Switch off the Torqeedo system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. “Charging” is shown in the display.
5. Fully charge the batteries.
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Torqeedo Cruise 3.0 FP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Torqeedo Cruise 3.0 FP in the language / languages: English, German as an attachment in your email.

The manual is 2.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Torqeedo Cruise 3.0 FP

Torqeedo Cruise 3.0 FP User Manual - Dutch, Danish - 92 pages

Torqeedo Cruise 3.0 FP User Manual - French, Italian - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info