807535
75
Zoom out
Zoom in
Previous page
1/92
Next page
75
DE EN
Move the accelerator lever to the neutral position to stop the motor.
»To continue travelling, you can simply give forwards/reverse motion again.
Pull off the emergency stop magnetic chip to stop the motor.
»To continue travelling, replace the emergency stop magnetic chip.
»Set the accelerator lever to the neutral position.
NOTE! Pressing the emergency skill switch or pulling the kill switch cord
switches the system off. To put it back into operation, it must be restarted.
NOTE! Do not use the emergency kill switch or pull the kill switch line cord
switch off the system regularly if there is no emergency situation.
Press the emergency kill switch or pull the kill switch cord.
»To continue travelling, reset the emergency kill switch or reinsert the kill
switch cord.
»Set the accelerator lever to the neutral position.
»Start the Torqeedo system.
Set the battery main switch to the OFF” position to switch off the system.
»To continue the journey, put the accelerator lever into the neutral position.
»Reset the emergency kill switch or insert the kill switch cord (if present).
»Set the battery main switch to the ON position.
»Start the Torqeedo system.
»Insert the emergency stop magnetic chip (if present).
8.2 Operation
8.2.1 Before travelling
Observe the following points before each use of your Torqeedo system to ensure
a safe trip.
Familiarise yourself with the travel area before setting off, as the range
shown in the onboard computer does not take into account wind, current
and direction of travel, and plan a sufcient buffer for the required range.
If there is visible damage to components or cables, the Cruise system must
not be switched on.
Ensure that everyone on board is wearing a lifejacket.
Attach the emergency stop magnetic pin lanyard or kill switch cord to the
skipper's wrist or lifejacket before launching.
The battery state of charge must be checked at all times while on the move.
Only apply the emergency stop magnetic chip or the kill switch cord when
there are no more people in the water (e.g. after bathing breaks), or remove
it immediately if people fall into the water to stop the drive.
Also observe all information from the “Safety” and “Before use” sections.
8.2.2 Switching on/off (Cruise 6.0 FP TorqLink only)
Switch on
1. Set the battery main switch to the ON position.
2. Depending on the conguration, press the “ON/OFF” button or operate the
key switch to switch on the system.
Switch off the system and batteries
1. Depending on the conguration, press the “ON/OFF” button or operate the
key switch to switch off the system.
»The system shuts down.
»The battery is switched off, only a very small self-discharge takes place.
2. Set the battery main switch to the off position.
8.2.3 Switching on/off (Cruise 3.0 FP only)
Switch on
1. Set the battery main switch to the ON position.
2. Depending on the conguration, press the “ON/OFF” button or operate the
key switch to switch on the system.
Switch off the system and batteries
NOTE! Power 24-3500 batteries cannot be switched off manually without the
additional on/off switch for Power 24-3500.
1. Depending on the conguration, press the “ON/OFF” button or operate the
key switch to switch off the system.
»The system shuts down, the battery remains switched on.
2. Set the battery main switch to the off position.
3. The battery switches off automatically after 48 hours if it is not used.
75


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Torqeedo Cruise 3.0 FP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Torqeedo Cruise 3.0 FP in the language / languages: English, German as an attachment in your email.

The manual is 2.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Torqeedo Cruise 3.0 FP

Torqeedo Cruise 3.0 FP User Manual - Dutch, Danish - 92 pages

Torqeedo Cruise 3.0 FP User Manual - French, Italian - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info