Manual Topcom Babyviewer 4500 - KS 4245 (page 6 of 85) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

484006

Zoom out

Zoom in

1/85

Babytalker 3500 SEDS

– To switch off VOX mode, select “OFF”.

– Press the menu button to confirm.

– After 10 seconds the parent unit will switch back to

monitor mode. The display will turn off until sound is

detected by the baby unit. In VOX mode, the VOX LED

will illuminate.

10.11 Night vision

The camera has 4 high-intensity LED’s for picking up clear images

in the dark. When the build in light sensor measures the

ambient light level as low, the LED’s will automatically activate.

11 Cleaning and maintenance

This section contains important instructions for cleaning and

maintaining the equipment.

Follow these instructions to ensure trouble-free use and prevent

damage to the equipment due to improper maintenance.

11.1 Safety Instructions

11.2 Cleaning

– Clean the equipment with a soft, slightly dampened

cloth.

– Clean soiled connectors and contacts with a soft brush.

– Clean the battery contacts and battery compartment with

a dry, lint-free cloth.

– If the equipment gets wet, switch it off and remove the

batteries immediately. Wipe the battery compartment dry

with a soft cloth in order to minimize potential water

damage. Leave the battery compartment open until it is

completely dry. Do not use the equipment before it is

completely dry.

11.3 Maintenance

– Check the batteries (regular or rechargeable) in the

equipment regularly and replace them when necessary.

– Check the connectors and cables for defects.

12 Troubleshooting

This section provides important instructions for localising and

correcting problems.

Follow these instructions in order to avoid hazards and damage.

12.1 Safety Instructions

12.2 Problem causes and solutions

The following table is intended to help you localise and solve

minor problems.

The VOX sensitivity is indicated by a black bar on

the display:

- high sensitivity

- low sensitivity

The image changes automatically into black and

white mode under the night vision mode.

DANGER

Risk of fatal injury due to electric shock!

• Before cleaning the equipment, switch it off and

unplug the power cable from the mains receptacle.

CAUTION

Risk due to leaking battery fluid

Fluid from leaking batteries (regular or rechargeable) can

cause injuries (skin irritation) or damage to the equipment.

Wear safety gloves.

CAUTION

• Do not use cleaning products or solvents. They can

damage the case or seep into the equipment and

cause permanent damage.

CAUTION

• If you suspect that the equipment is damaged, always

have it checked by an expert before using it again.

DANGER

Risk of fatal injury due to electric shock!

• Unplug the power cable before attempting to correct a

problem.

CAUTION

Risk of hazard due to incorrect repairs

Incorrect repairs can expose users to serious hazards and

cause damage to the equipment.

• Never attempt to modify or repair the equipment.

• Always have repairs to equipment or cables performed

by a specialist or the service centre.

• If you suspect that the equipment is damaged (for

example, if it has fallen on the floor), have it checked

by a specialist before you use it again.

Problem

Possible

cause

Solution

The rechargeable

battery pack of the

parent unit does

not charge

Charging station

plug not connected

Connect plug

Dirty contacts Clean the battery

terminals and

charging station

contacts with a soft

cloth

The rechargeable

battery pack is

defective

Replace the

battery pack

Parent unit does

not switch on

(display remains

black)

The rechargeable

battery pack is not

charged

Charge the battery

pack

Equipment

defective

Contact customer

service

The ‘out of range’

icon appears on

the parent unit

display

Baby unit not

switched on

Switch on the baby

unit

The parent unit and

baby unit are too

far apart

Reduce the

distance between

the parent unit and

the baby unit

The parent unit is

not registered with

the baby unit

unit with the baby

unit (see “12.3

Registering the

parent unit with the

baby unit”

The parent unit

does not reproduce

the sounds picked

up by the baby unit

The volume setting

of the parent unit

may be too low.

Increase the

volume setting of

the parent unit

The microphone

sensitivity of the

baby unit may be

set too low.

Check the VOX

sensitivity and the

volume setting of

the parent unit and

increase if

necessary.

Limited range and

interference during

transmission

The range of the

equipment

depends on the

surroundings.

Steel structures

and concrete walls

can impair

transmission.

Avoid obstacles as

much as possible.

The equipment

emits a high-

pitched whistle

The parent unit and

baby unit are too

close together

Increase the

distance to at least

2 metres

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Topcom Babyviewer 4500 - KS 4245 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 69,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Topcom Babyviewer 4500 - KS 4245 Manual

Product: