2) HRC set method,sequence, parameter range, press the program key to display HRC, press
the mode to confirm and enter the next setting, press the speed key to adjust, set the last
parameters to start.
3) Age setting range:13-80 years old
4) Target HRC setting range:80-180
5) Max HRC data: not over 220 - Age.
6) Bad HRC =(Target HRC-User’s HRC)
7) Speed change relationship;
A:Change frequency, HRC test the heart rate data every 30 seconds ( Heart rate data
keep displaying)
B:When the user's heart rate is lower than the target heart rate of 30 beats / min, the
speed increases by 2.0 km / h.
C:When the user's heart rate is lower than the target heart rate 6-29 times / minute, the
speed increased by 1.0 km / h.
D:When the user's heart rate is higher than the target heart rate 30 times / min, the speed
reduced by 2.0 km / h.
E:When the user's heart rate is higher than the target heart rate 6-29 times / min, the
speed reduced by 1.0 km / h.
G:When the user's heart rate is higher or lower than the target heart rate 0-5 times / minute,
the speed remains the same.
8) When the following conditions occur, the treadmill decelerates to a minimum within 20
seconds and stops after 15 seconds at the lowest speed and rings every second;
A:Every 30 seconds to detect a heart rate, when the two consecutive heart rate can not be
detected.
B:1 km / h (0.6 mph), heart rate leads to deceleration.
C:When the heart rate exceeds (220 - set the age).
1 km / h (0.6 mph), deceleration can not be less than 1 km / h (0.6 mph), such as: treadmill
minimum speed of 1 km / h (0.6 mph), when the treadmill run at 1.6 km / h (1.0 mph) and
slow down to 1 km / h (0.6 mph) when the heart rate is decelerating 1.0 (2.0) km / h.
9)
Incline not change when running, can be manually set. It will start to caculate in1 minute.
ECO function
:
Press the “ECO” key to enter into ECO mode. The treadmill will increase 3 levels based on
the current incline level. The min. incline level is 3. Press again the “ECO” key to quit the
ECO mode. Treadmill will decrease 3 levels based on the current incline, the min. incline is
0. In every time using, the default of treadmill is not in the ECO mode.
ERP sleep function:
System default for the ERP mode, when treadmill is under non operation state, about 4.5
minutes it enters a dormant state, save electricity, press any key to wake up the system.