Manual Toolland TC80100 (page 2 of 21) (English, German, Dutch, French, Portuguese, Spanish)

622633

Zoom out

Zoom in

1/21

TC 78009

Toolland | www.toolland.eu 2

WOOD STOVE VULCANUS

TC 80100

WARNING

For your own safety, read this manual

carefully before using the device.

SAFETY INSTRUCTIONS

When using the device, always observe the

enclosed safety instructions as well as the

additional safety instructions.

ADDITIONAL SAFETY INSTRUCTIONS

 Always wear heat-resistant gloves during

use.

 The minimum safety clearances from

adjacent combustible materials is as

shown on the last page of this manual.

 Smoke may appear during the first uses

of the stove, as certain components of

the heat-resistant paint burn whilst the

pigment of the actual stove is fixed.

 It is recommended to air the room until

the smoke disappears.

 The woodstove is not designed to

function with the stove door open under

any circumstances.

 The stove is intended to function

intermittently with intervals for

recharging the wood.

 For the lighting process of the stove it is

recommended to use paper, fire lighters

of small wood sticks. Once the fire starts,

add two logs of wood each weighting 1 to

1.3 kg as a first charge.

 During lighting the air inlets of the stove

must be kept completely open.

 If necessary the ash drawer can also be

opened a little.

 Once the fire has started, close the

drawer completely and regulate the

intensity of the fire by closing and

opening the air inlets.

 To achieve the stated nominal heat

output of this stove, you need to add

about 2 kg of wood every hour.

 The logs should be positioned horizontally

and separated from one another, to

assure a correct combustion.

 Do not add wood to the stove until the

previous charge has been burnt, leaving

only a basic fire bed which is enough to

light the next charge but no stronger.

 To achieve a slow combustion you should

regulate the fire with the air draughts,

which must be kept permanently

unblocked to allow the combustion air to

be distributed

 After the first lighting, the brass pieces of

the stove may get copper coloured.

 It is normal for the seal of the glass door

panel to melt with the use.

 Even though the stove can function

without this seal it is recommended that

you replace it every season.

 The lower drawer is meant to clear out

ash.

 Empty it regularly without waiting for it to

fill up too much to avoid damage to the

grill.

 Be careful with the ashes, as they may be

hot up to 24 hours after the stove has

been used.

 Do not open the door abruptly in order to

avoid smoke being released.

 Never open the door without opening the

air inlet first.

 Open the door only in order to add the

appropriate fuel.

 The glass, brass pieces and stove in

general may reach very high

temperatures. Do not expose yourself to

risk of burns.

 Keep children away from the stove.

 If you have trouble lighting the stove

(due to cold weather etc.) it can be lit

with folded or scrunched up paper which

is easier to light.

 In case of the stove becoming too hot,

close the air draughts to reduce the

intensity on the fire.

 In case of malfunction, contact the

manufacturer.

POSITION OF THE SMOKE PIPE

 Insert the right angled tube joint in the

smoke outlet at the back of stove.

 Attach the tube to the joint; repeat this

step for all tubes.

 Attach the pipe to the chimney.

INSTALLATION

 All locals regulations, including those

referring to national and European

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toolland TC80100 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toolland TC80100 Manual

Product: