748246
21
Zoom out
Zoom in
Previous page
1/64
Next page
EN - 21
9: Jam For preparing delicious, fresh jam. Cauon: Make sure the stones of the ingredients are removed
before you add them to the baking n. Sharp stones could damage the non-sck coang. Working
method: You add all ingredients to the baking n and set the machine to the JAM programme. Then
you press start and the machine rst starts to pre-heat the ingredients. Then the machine starts
to mix and eventually allows the jam to cool down. When the machine is ready, this is indicated
by means of a beep signal. You can pour the jam in a jar or container and allow it to cool further.
When cooled suciently, you can close the jar or container and store it in the fridge.
10: Cake By means of this programme you can make bread with baking powder, for instance, instead
of yeast. Loafs baked with this programme become less high and have a rmer structure.
The mer cannot be used at this posion, because the baking powder works immediately and
eventually no longer provides good leavening. If you want to make cake with this programme,
we recommend placing the ingredients in the baking n. Then you enter the sengs of the
machine and before you press start you must mix the ingredients with a wooden spoon.
This encourages the kneading process.
11: Sandwich Use this programme to make a very uy white loaf, for sandwiches for instance. Cauon! When
using this programme, you cannot select a crust colour, the machine does this automacally.
12: Bake You can use this programme for ready-made dough, that you made earlier for example. You can
only bake the dough with this programme. The programme is pre-programmed at 60 minutes.
In case of ready-made bread dough, observe the instrucons from the manufacturer. It is also
possible to reheat bread that has already been baked.
Step 1: Remove the baking n from the machine by turning it to the le by a quarter turn and pulling it straight out of the
machine by the handle.
Step 2: Place the dough hook (included) on the sha in the centre of the baking n. Carefully and correctly place the dough
hook, so that all ingredients are suciently mixed and kneaded. Always properly clean the sha, so that any baking
residues are completely removed.
Step 3: Add the ingredients to the baking n as follows and in the following order:
1. Half the required our/meal
2. Water/milk
3. Buer/oil
4. Eggs, if necessary
5. The rest of the required our/meal
6. Sugar (add the sugar on one side)
7. Salt (add the salt on the other side)
8. Yeast (add yeast in a lile hole created in the middle) Cauon: The yeast should not come into contact with the
water. It is possible that the water acvates the yeast before the ingredients are suciently mixed and kneaded.
Step 4: Remove all residues of ingredients from the outside of the baking n. Place the baking n back in the machine and
turn it to the right by a quarter turn, so that the baking n is in a good rm posion.
Step 5: Close the lid.
Step 6: Insert the plug into the socket. “3:00“ appears on the display.
Step 7: Set the right programme by means of the Menu buon.
Step 8: Use the COLOR buon to set the colour of the crust. You can choose between light (L), medium (M) and dark (D).
The chosen crust colour is shown at the top of the display by means of a “∆“.
Step 9: By means of the Loaf buon, select the correct size of the loaf that you want to make, 650 or 800 grammes.
The chosen size is shown at the top of the display by means of a “∆“.
Step 10: If necessary, set the me delay using the me delay buons (+/–). Also see: “Using the me delay.
Step 11: Press the start buon. The colon starts to ash, indicang that the machine is working.
* If you select one of these programmes, you cannot select a weight: Quick, Ultra fast, Dough, Jam, Cake and Bake.
For this, also see secon “Recipes”.
An overview of the exact programme mes can be found on the last page of the English instrucon manual.
The me on the display is indicated in hours and minutes. Example: Programme 1, Normal, medium crust colour takes 3 hours.
During the kneading process a “beep signal” can be heard: aer this “beep signal” you can add extra ingredients such as dry
currants, nuts or other products. You open the lid, add the extra ingredients and then close the lid, aer which the kneading
process connues. Cauon: Allow currants, raisins and nut to soak in advance, and dry them with a cloth or kitchen paper.
Make sure these ingredients are not too large or too sharp, or else the non-sck coang of the baking n could get damaged.
Step 12: When the loaf is ready, you can hear a number of beep sounds. Hold down the stop buon for a few seconds.
The machine will give another beep sound to conrm that the programme has been stopped. Remove the plug from
the wall socket and open the lid of the machine. Remove the baking n using oven gloves. Allow the loaf to cool down
in the baking n for about 10 to 15 minutes and turn the baking n upside down above your worktop and carefully
shake the loaf out of the n.
BAKING BREAD
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tomado TBM8001W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tomado TBM8001W in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info