658794
11
Zoom out
Zoom in
Previous page
1/30
Next page
QUICK GUIDE TO USING YOUR RECEIVER
P11
Please read the displayed instructions for each screen carefully. They will help you adjusting the settings fast and
easy.During the First Time Installation, you can press BLUE Next to go to the next step or YELLOW Previous to get
back to the previous step.
4.2 Audio and Subtitle Setup
Here you can set the Audio Language, Audio output, Subtitle Display and Subtitle Language. Use pq for selection
and tu to change settings. To see a list of all possible settings for the highlighted option, press OK. Once all
settings have been made, press BLUE Next to continue or YELLOW Previous to get back to the previous setup
screen.
Please read the displayed instructions for each screen carefully. They will help you adjusting the settings fast and
easy.
4.3 Auto DiSEqC Scan
In this menu the receiver will do an automatic scan for connected LNBs and suitable satellites. The most
common satellites as Astra 23.5E, Astra 19.2E, Astra 28.2E, HotBird 13.0E and Eutelsat 9.0E will be scanned for
availability. Please wait for a short time to let the receiver complete the scan and then apply the settings to
the next step by pressing OK at Next. Press OK at Previous if you have forgotten to connect a satellite cable or
need to correct anything else that was adjusted before. Once the Auto DiSEqC scan is finished and you have
confirmed with OK you will automatically receive at the next step of FTI.
To ensure reception and to scan the channels from your operator follow the Fast Scan method in the next steps.
For this the reception of Astra 23.5E is essential.
4.4 Satellite Selection
Depending on the results of the found satellites in the previous installation step it is possible to setup other
or additional satellites connected to your installation system. This might be useful if you have other satellites
installed on the LNB which are not commonly used ones or if the found satellites need rework.
To check or change your settings for the satellite(s) connected to the ports, use pq and press OK to enter the
submenu of your choice (LNB and the configured satellite will be according to Auto DiSEqC Scan result). This you
can do for up to 4 satellite positions. For a detailed description of this setup, please see chapter below. Once all
settings have been made, press BLUE Next to continue.
4.5 Channel List Selection
Here you can decide which of the Fast Scan channel lists you want to install. Use pq to highlight your
selection in orange coloured letters. Press OK to choose a list and the receiver will start the scan for the list
directly. Please, have patience as this takes some time. When the list has successfully been loaded, the First Time
Installation will be finished.
NOTE: The Fast Scan channel lists are maintained and updated automatically by the service list provider
and can’t be edited. Editing of channels can only be performed for channels which are saved above
channel number 4000 or additionally saved in favourite list(s). If you want to change to another
list you need to do a Factory Reset (see chapter 7.1.5 of the user manual on our website: www.
thomsonstb.net/downloads/manuals/THS813_UM_EN.pdf).
If the dish is pointed towards an incorrect satellite or if there is no signal or the signal from the satellite dish is
too low, the receiver cannot install channels and will go to the Main Menu. Please, first check the cables, the
alignment of the dish and the settings and try to setup again.
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at THOMSON understand that you can’t wait to enjoy your new HD receiver. The following quick guide will
make you familiar with the basic operation of this device. We do, however, advice you to read the full manual
on our website: www.thomsonstb.net/downloads/manuals/THS813_UM_EN.pdf to get the best performance
from your THOMSON HD receiver. To switch your receiver ON or to Standby, use the q button on the remote
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thomson THS813 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thomson THS813 in the language / languages: English as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info