480543
11
Zoom out
Zoom in
Previous page
1/31
Next page
P6
STARTING UP FOR THE FIRST TIME
3.4 Connecting and using the IR extender
Fig. 7
With the IR extender you can place the receiver out of sight (e.g. a closed cabinet) while still
being able to control it. Plug the IR extender into the IR connector on the back of the receiver.
Locate the extender at a position allowing a direct sight to the remote control. Once a suitable
location is found, remove the protection foil from the adhesive tape on the bottom of the
extender and fix it by slightly pressing it down on the surface it should be placed on.
NOTE: We recommend considering the standard adhesive notes (dust-free, fat free, not to coarse
materials, etc.)!
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your satellite signal is of good quality and that all connections are properly setup. In
case of difficulties or questions, please ask your local dealer for assistance. It is recommended
to follow the First Time Installation step by step. It will guide you through the basic installation
and channel searching process. You can enjoy digital HD broadcasts within just a few minutes.
4.1 Language, Country and Video Setup
After turning on the power for the first time, the OSD language, Country and Video Setting
menus will be shown. Choose your language with
tu then use pq to select your preferred
country. For these settings you can also use OK to show a list of available settings.
Please read the displayed instructions for each screen carefully which will help you adjusting the
settings correct and easily.
In the Video settings use
tu to choose which connection you are using, either HDMI or Scart are
available. The desired connection can be opened with OK to set the appropriate settings.
During any stage of the First Time Installation, you can press BLUE Next to go to the next step
or YELLOW Previous to get back to the previous step.
NOTE: For Austria and satellite Astra 19.2 you have the possibility to load a preset channel list.
4.1.1 HDMI
In this submenu you can set following parameters:
TV Ratio: 16:9 or 4:3 to choose depending on the kind of your TV set.
Conversion: Letterbox, PanScan or Combined, to choose the preferred picture format.
Video Output: Only selectable for Scart
Resolution: 576p, 720p or 1080i, to adjust the optimum resolution your TV set
supports.
HDCP: ON or OFF, please see the Note below.
NOTE: HDCP (High Definition Content Protection) is set to ON per default as nowadays all TV sets with an
HDMI connector support HDCP. In case you have problems with the HDMI connection you can use the Scart setting
to deactivate HDCP, which will allow you to watch via HDMI without problems. Please consider that movies which are
broadcasted with an extra content protection might not be shown in case HDCP is set to OFF.
4.1.2 SCART
In this submenu you can set following parameters:
TV Ratio: 16:9 or 4:3 to choose depending on the kind of your TV set.
Conversion: Letterbox, PanScan or Combined, to choose the preferred picture format.
Video Output: RGB or CVBS, depending on what your TV set supports. For Scart
we recommend RGB.
Resolution: Only selectable for HDMI
HDCP: ON or OFF, please see the note above.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thomson THS 810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thomson THS 810 in the language / languages: English as an attachment in your email.

The manual is 1,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info