682707

Thomashilfen tRide Manual

18
Zoom out
Zoom in
Previous page
1/112
Next page
18
Fitting the seat unit
The lever on the headrest frame serves on the one hand to separate the seat unit from the subframe and on the other to
adjust the seat tilt angle. Hold down the lever on the headrest frame of the seat unit (fig. 3).
Insert the seat unit into the mounting adapter on the chassis and ensure that the pins on the side of the seat unit engage
in the recesses designed for this purpose. Bring the seat into the upright position until you hear it securely click into place.
Then check that the seat is properly locked in-place by pulling forwards on it (fig. 4).
Removing the seat unit
The seat can be removed from the subframe without the use of tools. Hold down the lever on the headrest and tilt the
seat unit backwards. The seat unit can then be removed by lifting it diagonally backwards and upwards out of the
mounting adapter on the chassis. It is recommended that you first lock the foot brake in the on position.
Fitting the footrest
The footrest must be secured at the toggle joints. To do this, place the ratchet joints one above the other and secure with
the screws (lever the inside), the washers (lever the outside) and the wing nuts (lever the outside) (fig. 5).
Lateral backrest upholstery
Place the lateral backrest upholstery over the lateral tube and use Velcro to fasten the upholstery to the curved lateral
parts of the back section (fig. 6). Completely close the Velcro – including over the knurled screw. Also use Velcro to
secure it to the back section (fig. 7).
Locators for weather canopy
The tRide rehabilitation stroller is fitted with locators to fit a weather canopy as standard (fig. 8)
Seat upholstery
Use Velcro to secure the seat upholstery to the seat. The two lower Velcro straps should be secured around the footrest
tubes (fig. 9).
Footrest tube padding
Use Velcro to secure the footrest tube padding around both the left and right tubes beneath the toggle joints.
Mounting the belts
Pass the two upper belts depending on the size of the child to either both inner or both outer loops of the back upholstery
and attach them to the rear of the backrest with the cam buckles. (Fig. 10)
The two bottom belt ends can be attached with the cam buckles to either the back plate or to the side of the plastic
element. (Fig. 11-13) Guide the belts left and right next to the back upholstery to the corresponding cam
buckle and fix them.
Tip: The belt length can also be adjusted from the front. Pull the D-ring to shorten the belt.
Basket
Fasten the basket (with its opening to the rear) to the four crescent rings on the frame using the spring clips (fig. 14a+b).
The basket may remain attached when folding the tRide. (Maximum loading of the basket: 5 kg).
Parking brake function
Please remove the cable tie that locks the foot brake.
Lock: Place your foot on the brake bar and press downwards.
Release: Place your foot underneath the brake bar and slide it upwards.
CAUTION: The brake release force is higher than usual in order to provide improved braking performance.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thomashilfen tRide at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thomashilfen tRide in the language / languages: All languages as an attachment in your email.

The manual is 1,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info