648122
6
Zoom out
Zoom in
Previous page
1/24
Next page
7) Using the pilote wire
The product with pilote wire can receive the following signals from a master
unit :
- comfort (temperature of control knob), (model Vivalto, Evidence Elec)
- eco (comfort temperature -3°C to -4°C), (model Vivalto, Evidence Elec)
- frost free (approximately 7°C)
- off.
Put the switch (1) to the programming mode (clock symbol).
The product must be connected through the pilote wire to a programming
control or a product equiped with pass program system in order to use
these different modes. You can control several convectors with a single
programmer or a product equiped with pass program system.
Warning :The control unit will consider frost free and off signals in any
switch selection.
RECOMMENDATIONS FOR USE
- There is no point in setting maximum heating, the room temperature will
not rise any quicker.
- When you air the room, disconnect the panel heater by putting the
switch to
/0.
- If you leave for several hours, remember to reduce the temperature.
Absence for :
less than 2 hours, do not touch the controls.
2 to 24 hours, lower the control knob by two graduations, set the
cursor switch knob to .
more than 24 hours or in the summer, put the control knob to
(mecanical), put the switch on (electronic).
- If you have several units in a room, let them operate simultaneously. This
will give you a more uniform temperature without increasing electricity
consumption.
WARNINGS
Children must not lean on the appliance. Under certain circumstances,
there is a risk that its surface may cause burns to the skin of young
children. If there is any risk of this at all, install a protection grill.
This device is not intended for use by persons (including children)
with physical, sensory or mental disability, or by persons lacking
experience or knowledge, unless they have received from a person in
charge of their safety adequate supervision or preliminary instructions
on how to use the device.
Care must be taken at all times to keep children from playing with
the device.
Do not introduce objects or paper into the device.
Do not totally or partially block the grilles on the front or inside of the
appliance, as this may cause overheating. If the supply cord is damaged,
it must be replaced by a service agent or similarly quali ed person in
order to avoid a hazard (applies to all units). All work to the inside of the
appliance must be carried out by a licensed electrician.
MAINTENANCE
To maintain performances of your unit, you should clean the upper and lower
grilles of the unit about twice a year using a vacuum cleaner or a brush.
Have a professional check the inside of the unit every ve years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This
phenomenon is due to the poor quality of the ambient air. In this case, it
is recommended to check that the room is well ventilated (ventilation, air
inlet, etc.), and that the air is clean. The unit will not be replaced under the
guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive
products.
TROUBLE-SHOOTING
If the unit does not heat :
Check that the programmer is in COMFORT mode (electronical).
Make sure that the installation circuit breakers are switched on, or that the
load shedder (if you have one) has not switched off the unit power supply.
Check the air temperature in the room.
The unit does not carry out programming orders : (version with pilot
wire)
Make sure that the programming unit is being correctly used (refer to its
user’s manual) or that the Chronocarte is properly inserted in its housing and
that it is operating normally (batteries ?).
The unit is permanently heating :
Make sure that it is not in a draft and that the temperature setting has not been
changed.
This unit with electronic control is equipped with a microprocessor that can
be distribued by some severe mains voltage disturbances (outside EC
standards de ning the disturbance protection level). If there are any
problems (thermostat blocked, etc.) switch off the unit power supply (fuse,
circuit breaker, etc.) for about 5 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the
phenomenon occurs frequently.
WARRANTY CONDITIONS :
KEEP THIS DOCUMENT IN A SAFE PLACE
(This certi cate should only be produced if you are making a complaint, attached with the invoice of the purchase)
- This guarantee is applicable for 2 years from the date of original purchase and shall be valid for no more than 30 months from the date of manufacture.
- Your Atlantic distributor will exchange parts shown to be defective in manufacture. The replacement parts will be of charge but Atlantic does not accept
responsability for freight or labor charges or losses in transit.
- This guarantee excludes damage by neglect, shipping or accident and any damage due to incorrect installation, use or purposes other than those intended
or failure to observe the instructions given.
* This information is shown on the plate which can be seen on the left-side or behind the front grille of the unit.
Atlantic UK Limited - The Old Mill - Mill Lane - Uck eld - East Sussex - TN22 5AA
Tel: 01825 767474, Fax : 01825 767478
E-mail: sales@atlantic-uk.co.uk
UNIT TYPE * :
SERIAL NUMBER * :
CUSTOMER’S NAME AND ADRESS :
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermor Vivalto at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermor Vivalto in the language / languages: English, German, Dutch, Danish, French, Polish as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info