532670

Thermocet Trimline Quadro 46 Manual

4
Zoom out
Zoom in
Previous page
1/85
Next page
Page.4
The unit has a layer of heat-resistant varnish that resists very high temperatures.
An unpleasant smell may develop in the first hours after starting the unit due to burning
in of the varnish; however, this is not dangerous. To accelerate this process, allow the
unit to burn at the highest setting for several hours and ventilate the area well.
After the first time the unit is turned on, a light deposit may form on the inside of the window.
This is due to the varnish hardening. After the fireplace has cooled down, this deposit can
be removed using a fireplace glass cleaner or ceramic hotplate cleaner.
4.1 Maintenance and cleaning
Daily maintenance
Avoid having a lot of dust and cigarette smoke, candle and oil lamp particles in the air
of your home. Heating of these particles through the convection system of the unit, can lead
to discolouring of walls and ceilings. It is therefore advisable to ensure the area containing
the unit is always sufficiently ventilated.
Regularly remove any dust that has settled behind the operating lid with a vacuum cleaner.
The unit must be switched off immediately if something is spilt on it. It should only be cleaned
once the unit has cooled down. Never use abrasive, aggressive cleaning products or fireplace
cleaner; only use a dry cloth that does not give off fluff.
Cleaning.
The unit should be cleaned and checked every year by your dealer.
The Concentric flue system must be cleaned every 2 years.
From dealers aerosols available heat-resistant paint? Bier, so that the annual
maintenance small stains or damages may be touched.
Also Verification:
1 Density of the gas combustion products and combustion air feed circuit.
2 The correct operation of the gas control block and the ignition of the burner.
If the glass is broken or cracked, it should be replaced immediately by a recognised fitter
before the unit is used again.
4.2 Important tips for gas heating or wood fuelled units and fireplaces.
Prevent discolouration of walls and ceilings!
There are always particles in the air in each living area even if the area is vacuum cleaned regularly!
These particles are easily visible when the sun streams in. This issue will not arise if the amount
of particles in the air is limited. If these particles are present in greater quantities and particularly
if the air is contaminated by soot and tar particles, for example, through the burning of candles or
oil lamps and cigarette or cigar smoke, then we can speak of a poor inner climate! Cooled air slowly
lows over the floor to the heater in a heated living area. This air is heated in the convection system
of the fireplace or heater, resulting in a quickly rising column of air that subsequently spreads through
the room again. This means there is always dust and other polluting particles depositing on cold and
often damp surfaces. This issue occurs especially in a new building (building damp) that is not yet dry.
An undesirable consequence of this phenomenon could be discolouration of walls and or ceiling!
How can this problem be avoided?
* With a newly built fireplace or following renovation, wait at least 6 weeks before firing up.
* The building damp must have disappeared completely from the walls, floor and ceiling.
* The room where the unit is located must be well ventilated.
* The required air ventilation must be in line with local building regulations.
* Limit the use of candles and oil lamps and keep the taper as short as possible.
* These two creators of atmosphere ensure considerable quantities of polluting and unhealthy
soot particles in your flat.
* Among other things, cigarettes and cigars contain tar that will precipitate on cold and damp
walls during heating.
* This may occur above radiators and light fittings and with ventilation grilles (if there is a poor
internal climate), although to a lesser degree.
4. THE FIRST FIRING
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermocet Trimline Quadro 46 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet Trimline Quadro 46 in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 5,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thermocet Trimline Quadro 46

Thermocet Trimline Quadro 46 Installation Guide - English - 85 pages

Thermocet Trimline Quadro 46 Usermanual and installation guide - English - 34 pages

Thermocet Trimline Quadro 46 Installation Guide - German, Dutch - 85 pages

Thermocet Trimline Quadro 46 Usermanual and installation guide - Dutch - 34 pages

Thermocet Trimline Quadro 46 Installation Guide - Danish, French, Spanish - 85 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info