607253
5
Zoom out
Zoom in
Previous page
1/26
Next page
Page 5
Warning!
You must ascertain whether gas can be smelled around the unit before switching it on. Some gases are
heavier than air and can be found at floor level. You should therefore also determine whether you can
smell gas at floor level.
Failure to follow the instructions below exactly may lead to damage to personal possessions and may lead to
personal injury or even death.
What you should do if you smell gas:
* Do not ignite or switch on any units.
* Do not switch any electrical switches on or off.
* Do not use a telephone in the building. If necessary, go to your neighbour and ask
whether you may telephone the gas supplier. Follow the supplier’s instructions.
* If you cannot reach the gas supplier, call the fire brigade.
2.1 Functions of remote control
A temperature sensor in the remote control measures the ambient temperature.
The remote control compares the ambient temperature with the set temperature and then sends a signal to the re-
ceiver which controls the gas block motor in order to change the flame height upwards or downwards.
The battery should be replaced when the signal is noticeably weak.
Setting of the temperature (ºC and ºF) in the display.
After fitting the 9V battery, the temperature (ºC) and or (ºF) and the time display can be changed (24 hours or 12
with AM/PM) by pressing in buttons B2 and B3 at the same time.
By pressing in buttons B1 and B2 you can set the time after which B1: hours, B2: minutes.
The display will automatically return to the start setting. This can also be done by pressing button B3.
Setting the desired day temperature.
Press button B4 (1x) until * appears in the display.
Hold button B4 down for a little longer until the temperature reading begins to flicker.
Then the desired day temperature can be set by using buttons B1 and B2.
Wait or press button B3 again and the display will return to the start.
Setting the desired night temperature. )
Press button B4 (2x) until
) appears in the display.
Hold button B4 down for a little longer until the temperature reading begins to flicker.
Then the desired night temperature can be set by using buttons B1 and B2.
Wait or press button B3 again and the display will return to the start.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermocet Coventry S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet Coventry S in the language / languages: English as an attachment in your email.

The manual is 3,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info