782615

Thermex ID - shadow Manual

4
Zoom out
Zoom in
Previous page
1/128
Next page
2
Table 1
Model
EWH useful
volume, l
Installation
ID 30 V (shadow)
25
vertical
ID 50 V (shadow)
42
vertical
ID 80 V (shadow)
67
vertical
ID 100 V (shadow)
84
vertical
ID 50 H (shadow)
42
horizontal
ID 80 H (shadow)
67
horizontal
4. DESCRIPTION AND PRINCIPLE OF OPERATION
The outside casing of the EWH is made of impact-resistant plastic. Inner tanks have a
special bio-glass-porcelain coating reliably protecting the inner surface against chemi-
cal corrosion. The space between the outside casing and the inner tank is filled with
polyurethane foam - a modern, ecologically clean thermal insulation, which has the best
heat-saving characteristics. ID (shadow) models have two screwed nozzles: for inlet of
cold water (Figure 1, p. 3) with a blue ring and for outlet of hot water (Figure 1, p. 2)
— with a red ring, and equipped with an additional drain connection (closed with metal
plug button) for draining the water and flushing the inner tank (Figure 1, p. 17). The
control panel, in all models, is on the front side of the EWH. (Figure 1, p. 16).
Tubular heating element (THE), thermostat and thermal switch sensors are mounted
on the removable flange. THE is used to heat water and thermostat provides with pos-
sibility of heating temperature regulation up to +65°С. All models have electronic
control with sensor adjustment. Electronics maintain automatically water temperature
at the level set by the user. The thermostat is used for protecting against EWH over-
heating, which disconnects THE from power supply when water temperature exceeds
95°С. (Fig. 3).
Safety valve (Fig. 1, p. 5) operates as the check valve, ensuring protection of the water
ingress from the water heater into the sewage system in case of pressure drop in the
sewage system and in case of pressure rise in the tank at high water heating, as well as
the functions of the safety valve, releasing overpressure in the tank at high water heat-
ing. During water heater operation water may leak out of the exhaust outlet pipe of the
safety valve to relieve excessive pressure, which is made for the purpose of water
heater safety. This outlet pipe shall remain open to the atmosphere and be installed
constantly down.
Drainage of water from the safety valve exhaust pipe into the drain shall be pro-
vided with installation of the corresponding EWH drainage.
It is required regularly (at least once a month) to discharge a small amount of water
through the exhaust pipe of the safety valve into the drain to remove lime deposits and
ы
EN
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermex ID - shadow at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermex ID - shadow in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info