606550
64
Zoom out
Zoom in
Previous page
1/71
Next page
Continuous valve actuator CHEOPS control
theben
As of: Jul-11 (Subject to change without notice) Page 64 of 71
Table 29: General, for every hard and software version.
Response
Potential cause
Remedy
Valve does not close when
actuating value is 0%
Valve seal is insufficient for
pressing onto the valve seat
Enter additional pressing of
rubber seal.
Caution: Increase parameter
by max. increments of 10.
OR (from 2008):
Choose another calibration
strategy.
Valve seal is damaged
Replace valve.
Valve opens only with an
unexpectedly large actuating
value
Existing valve seal is too soft
Adapt parameter type of valve
seal.
Valve opens only with
actuating values over:
5% Standard valve seal
10% medium-soft seal
20% select soft seal
Valve does not move to
positions below or above a
certain value
Minimum or maximum
actuating value parameter(s)
have been changed
Check minimum and
maximum actuating value
parameters
No LED display and no
automatic adaption
after reset
Device was unloaded with
ETS software
Reload individual address
+ application program
Error message with ETS
device info / Application
program:
Run state
Halted
Device was unloaded with
ETS software
Reload individual address
+ application program
6.1 Display current valve position
The current valve position can be viewed by simultaneously the blue and red buttons.
Position:
80..100%
60..80%
40..60%
20..40%
1..20%
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Theben CHEOPS control KNX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Theben CHEOPS control KNX in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Theben CHEOPS control KNX

Theben CHEOPS control KNX User Manual - English - 1 pages

Theben CHEOPS control KNX User Manual - German - 72 pages

Theben CHEOPS control KNX User Manual - German - 1 pages

Theben CHEOPS control KNX User Manual - Dutch - 76 pages

Theben CHEOPS control KNX User Manual - French - 74 pages

Theben CHEOPS control KNX User Manual - French - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info