576769
6
Zoom out
Zoom in
Previous page
1/33
Next page
44
seconds before reinserting them. Once the indoor data is displayed, user may
proceed to the next step.
3. After the batteries are inserted, the Temperature Station will start receiving data
signal from the transmitter.
4. If the optional probe has been plugged to the dual channel transmitter, the outdoor
temperature should then be displayed on the Temperature Station on channel 1 and
2. Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
Note:
Channel 1 will show the reading from the internal sensor of the dual channel transmitter;
Channel 2 will show the reading sensed by the probe. If the probe is not plugged to the
transmitter, " - -" will be shown on Channel 2.
5. In order to ensure sufficient 868 MHz transmission, the final position between the
Temperature Station and the transmitter should not be more than 100 meters (see
notes on “Positioning” and “868 MHz Reception”).
6. Once the remote temperature has been received and displayed on the Temperature
Station, the DCF time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions—but may take up to 4 nights.
When two transmitters are used
1. User shall remove all the batteries from the Temperature Station and transmitters and
wait 60 seconds (if setting has been done with one transmitter before).
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TFA 30.3032.10.IT - Easy Go at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TFA 30.3032.10.IT - Easy Go in the language / languages: English as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of TFA 30.3032.10.IT - Easy Go

TFA 30.3032.10.IT - Easy Go User Manual - German - 38 pages

TFA 30.3032.10.IT - Easy Go User Manual - Dutch - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info