automatically toggled to display. However, if the probe is unplugged, the transmitter' s
display will only show the reading from the inner transmitter.
Once the transmitter is successfully recognized by the temperature station, Channel 1 of
the Temperature station will display the temperature data measured by internal sensor and
Channel 2 will display the temperature estimated by the probe.
If the measuring probe is unplugged, the "probe channel" on Temperature station will show
"---", yet the data from the internal transmitter will still be shown on Channel 1 .
The probe can be connected to the remote temperature transmitter anytime after initial
setup. There is no need to reset the units, should the probe be unplugged or re-plugged
again. The Temperature Station will automatically detect the temperature probe data and
will display the temperature data on Channel 2 after the probe is plugged.
SETTING UP:
When one transmitter is used:
1. First, insert the batteries into the transmitter (see “Install and replace batteries in
the Temperature transmitter” below).
2. Within 30 seconds of powering up the transmitter, insert the batteries to the
Temperature Station (see “Install and replace batteries in the Temperature
Station” below). Once the batteries are in place, all segments of the LCD will light up
briefly. Then the indoor temperature and the time as 0:00 will be displayed. If they are
not shown on LCD after 60 seconds, remove the batteries and wait for at least 60
