636724

Texas GTU26S Manual

10
Zoom out
Zoom in
Previous page
1/17
Next page
6
Start and stop
How to start a cold engine
1. Place the brush cutter on a flat stabile surface.
2. Set the switch to ( I ). See il.. 6A
3. Press 8-10 times on the fuel pump under the air filter,
see ill. 6B.
4. Set the choke lever to start position, see ill.7
5. Pull the start cord out slowly from engine until resistance
is felt. Then pull strongly in start cord. Always feed the
start cord back into the engine by hand. Repeat up to 3
times until initial ignition is heard.
6. Set the choke lever to drive position, see ill. 8
7. Pull the start cord (according to point 5) until the engine
runs.
How to start a warm engine
1. Set the choke lever to drive position, see ill. 8
2. Pull the start cord until the engine runs.
How to stop the engine
1. Release the throttle button.
2. Set the switch to ( O ) position, see ill. 6A
Vibrations may travel up into the handle during
use. We therefore recommend taking a break
every 2 hours.
Operating the machine
Remove all foreign objects from the work area before
using the machine. Stones, glass, branches and similar
items may damage the machine. Also check the bolts
are tightened.
Start the motor as per the instructions below. Stand
clear of the machine’s moving parts.
Never attempt to move the machine in any way other
than intended for normal use while the motor is running.
Work from left towards right, see ill. 9.
Cleaning
The machine should be cleaned after use. Use a garden
hose to wash off soil and dirt. Remove the trimmer head from
the trimmer axel to remove wedged grass etc. from the rotor
shaft. The chassis number should only be cleaned with a
damp cloth to avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
Storage
• If the machine is likely to be stored unused for
prolonged periods, follow the instructions below.
This will ensure longer machine lifetime.
• Use a garden hose to wash off soil, grass and dirt.
Remove any grass, etc. from the shaft. The chassis
number should only be cleaned with a damp cloth to
avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
• Wipe the machine with a damp cloth so that all
surfaces are clean. Wipe the surfaces down with an
oily cloth to prevent rust.
• Always store the machine in a dry, clean location.
Troubleshooting
The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
The motor is not running smoothly
1. Check there is fresh gas in the tank.
The trimmer will not rotate
1. Check the cables are in good working order and
fitted correctly.
2. Check and remove wedged grass.
Noise, vibration and precautionary measures
1. Long-term exposure to noise levels exceeding 85 dB
(A) are damaging. Always use ear defenders when
the machine is being used.
2. Reduce the running speed of the motor to reduce
vibration and noise levels.
3. To reduce noise levels further, only use the machine
in an open environment.
4. Vibrations can be reduced further by holding the
handle firmly.
5. Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with
steel toecaps.
6. Take a 30-minute break every 2 working hours.
Specification
TYPE GTU26S
Connections Flexible drive
shaft without
clutch
Handle D-handle
Weight w/o fuel (kg) 5.5
Engine size (cc) 26
Output (KW) 0,7
Spark plug (item #) Denso
W22MPR-U
(10011022)
Carburetor Membrane type
Start Recoil
Fuel Lead free 95
octane gasoline
mixed with 2
stroke oil.
Tank capacity (L) 0,6
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas GTU26S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas GTU26S in the language / languages: English, German, Danish, French as an attachment in your email.

The manual is 2,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info