704023
18
Zoom out
Zoom in
Previous page
1/28
Next page
18 • CP 5100 DR
Radio playback
Select one of the three radio broadcast bands (see page
12):
FM AUTO – Reception of stereo stations from 87.5 to 108
MHz, RDS mode possible.
FM MONO – Reception of weak stations in mono, RDS
mode possible with limitations.
AM – Reception of mono stations from 522 to 1,629 kHz.
Setting the radio stations
Direct entry of the tuning frequency:
Briefl y push the button 35 “Tune.
Enter the frequency without any decimal or comma
using the number buttons 551 ... 0”.
Push the selection button 42”.
Station scan:
You can change the receiving frequency with the buttons
33 :
Automatically : Pressing the button will start the station
scan in the desired direction, which will continue until a
station with suf cient broadcasting power is received.
Manually : The frequency is gradually increased and/
or decreased every time you tip the button (FM: 0.05
MHz step, AM: 9 kHz step).
The set tuning frequency is shown in the display 5. If the
station is received in stereo, the message “STEREO” will
also appear. If the station broadcasts an RDS signal, then
the message “R•D•S” will appear and the name of the
station will replace the frequency display after a short
time.
Station memory
Your radio can save up to 30 stations for each of the two
radio bands (FM and AM). You can select the saved sta-
tions conveniently with the push of a button.
Presetting stations
Tune in the desired station as described above.
Press the select button 42. The display now shows
an available memory slot by a blinking number, e. g.
“P01.
You can select the desired memory slot with the
number pad 551...0”. You can change the tens deci-
mal place with the button 54 “+10”.
Press the select button 42” again. The message
“SAVE OKAY” will appear briefl y in the display.
The station has now been saved. If there is no button
activity for fi ve seconds, the device will switch back to
normal mode.
54
35
41
33
55
Saving stations automatically
Push the button 35 “Tune” for approx. six seconds until
the message “APS Start” appears in the display panel.
The radio is now searching for stations with adequate
reception and automatically saves them. Previously saved
stations are deleted in the process.
After the search ends, the station is saved to the memory
slot 01.
Tuning in stations from the memory
You can directly choose stored stations by using the
number pad 55. With the button 5410+” you can ac-
cess the memory slots with two-digit numbers.
91341 GB 20100924.indd 1891341 GB 20100924.indd 18 24.09.2010 9:58:08 Uhr24.09.2010 9:58:08 Uhr
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teufel Cinepaq 5100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teufel Cinepaq 5100 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info