703901
9
Zoom out
Zoom in
Previous page
1/28
Next page
• CP 5100 DR 9
FM antenna
Connect the antenna for receiving FM/VHF stations to
the jack 13 “FM. This can be a roof/outdoor antenna or
a cable television connection. You will need a coaxial
cable for this.
If an antenna connection is not available at your setup
location, you can use the enclosed dipole FM antenna
. Unwind the throw-out aerial, screw the lugs onto
the adapter
, push the
adapter into the jack 13
“FM” and adjust the position
of the throw-out aerial until
you have the best reception.
Then fi x the antenna in place
with tape or a nail.
13
Setup and Connecting
Setup location
Select a stable, level base.
Make sure that the environment is clean and free from
dust.
Avoid placing the unit close to sources of heat or in
direct sunlight.
Arrange the connector cables so that they do not pose
a trip hazard.
Do not place any heavy objects on top of the cables or
the unit.
There should be approximately 10 cm of space around
the device to enable adequate air circulation.
Connecting the speakers
To connect the speakers, use high-quality, two-conductor
speaker cable with a diameter of at least 1.5 mm
2
(AWG
15). You can order cables and banana plugs in our web-
shop (www.teufelaudio.com) in the “Accessories” area.
the small cap that covers top entry of terminals 22 and
then push the plug into the visible jack of the connector
terminal.
If you don’t use any banana plugs,
turn the connector terminal 22
counterclockwise to loosen it. Insert
the stripped cable end into the hole
that is now visible. Turn the terminal
clockwise. This will clamp the cable
in place.
Subwoofer
You can connect an active subwoofer to the RCA jack
25 “Sub Out. Only low frequency audio signals will be
issued at this jack up to an adjustable frequency.
Antennas
Danger
Risk associated with lightning strike!
If you are using outdoor or roof antennas, be
absolutely sure that the antenna has lightning
protection.
The connector terminals 22 “Speakers” for the fi ve satel-
lites are located on the back of the DVD receiver:
Front – front speakers, “Left”and “Right”.
Center – middle speakers.
Rear – rear speakers, “Left” and “Right”.
The terminals are each marked red (+) and black (-).
Observe the correct polarity!
Connect the like coloured terminals with each
other. Otherwise the sound quality will suffer.
The wires of the speaker cables are marked with differ-
ent colours or shapes.
Split the speaker cable on both
ends over a length of about 30 mm
and remove approximately 10 mm
of the insulation sheathing. Twist
the cable to ensure that no wires
protrude.
Connecting the cables to the speakers should be de-
scribed in the operating instructions for the speakers.
If you use banana plugs, screw the cord into place on
the plug (see instructions for the banana plug), remove
2225
91341 GB 20100924.indd 991341 GB 20100924.indd 9 24.09.2010 9:58:00 Uhr24.09.2010 9:58:00 Uhr
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teufel Cinepaq 3100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teufel Cinepaq 3100 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Teufel Cinepaq 3100

Teufel Cinepaq 3100 Additional guide - English - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info