485894
14
Zoom out
Zoom in
Previous page
1/48
Next page
ENGLISH
SAFETY REQUIREMENT
This booklet is an integral part of the appliance and must be carefully read before use,
since it provides important information on the installation, safety, use and maintenance of
the appliance. Keep in a safe place.
• After removing the packaging make sure the appliance is undamaged and that no parts
are missing. If in doubt, do not use and contact an authorised Termozeta service centre.
Do not leave parts of packaging (plastic bags, foam polystyrene, nails, etc) within reach of children
or unqualified persons since they are potential sources of danger.
• If the appliance comes with an earth plug, the electrical safety is ensured only when this plug is
correctly connected to an effective earthing system in compliance with the existing electrical safety
standards.Termozeta shall not be held responsible for any damages caused by the lack of a correct
earthing system.
• Before connecting the plug to the power outlet check that the operating voltage of the appliance
corresponds to the voltage of your mains supply. If in doubt, contact a qualified technician.
Do not use adaptors, multiple plugs and extension leads. If necessary, only use devices that
conform to the current safety standards making sure they are compatible with the power of the
appliance. If in doubt, contact a qualified technician.
• Any installation not conforming to the above instructions may compromise your safety and cancel
the guarantee.
The machine is exclusively for domestic use for sewing fabrics.
For safety reasons:
- do not use the appliance with bare feet and with wet hands or feet
- do not use the appliance outside the home
- do not leave the appliance exposed to atmospheric agents (sun, rain…)
- do not allow the machine to be used by children or by anyone with reduced physical or mental
abilities or without experience unless they are supervised and instructed on its use.
- never pull on the power cord or on the appliance itself to disconnect the plug from the power outlet
- do not leave the appliance unattended when it is plugged into the main power supply
- never immerse the appliance in water or other liquids.
The power cord of the appliance must not be replaced by the user. If necessary, contact an authorised
TERMOZETA service centre or qualified technician.
• Switch off and do not tamper with the appliance should it breakdown and/or not function properly.
Contact an authorised TERMOZETA service centre for any repairs and ask for original spare parts.
Make the appliance unserviceable at the end of its running life by unplugging it from the power outlet
and cutting the power cord. Abide by the existing standards in your country for instructions on its
disposal.
Termozeta cannot be held responsible for any damages to people animals or things caused by
incorrect installation or due to improper, incorrect or negligent use.
Do not put fingers near the moving parts. Pay particular attention to the area around the
sewing machine needle.
• Always use the correct needle plate otherwise the needle could break.
• Do not use bent needles.
• Do not push or pull the fabric during sewing. The needle could bend and break.
• Switch off the sewing machine (“0”) whenever any adjustments have to be made in the needle area,
e.g. change needle, thread a bobbin or change the foot etc.
INDEX
SECTION 1. NAMES OF PARTS
Names of Parts pag. 14
Standard Accessories pag. 14
SECTION 2. GETTING READY TO SEW
Connecting machine to power supply pag. 14
Reverse stitch control pag. 14
Presser foot lifter pag. 14
Changing presser foot pag. 15
Extension table pag. 15
Stitch selector pag. 15
Changing needle pag. 15
Selecting needle and thread pag. 15
Bobbin winding pag. 16
. Removing bobbin case pag. 16
. Bobbin winding pag. 16
. Inserting bobbin pag. 17
Threading the machine pag. 17
. Threading the machine pag. 17
. Drawing up bobbin thread pag. 18
Adjusting the needle thread tension pag. 18
. Balanced tension pag. 18
. Tension is too tight pag. 18
. Tension is too loose pag. 18
SECTION 3. BASIC SEWING
Straight stitch pag. 19
Turn a square corner pag. 19
Basic zigzag pag. 19
Overcasting stitch pag. 19
Multiple zigzag stitch pag. 19
Blind hem stitch pag. 20
SECTION 4. DECORATIVE STITCHES
Shell tuck pag. 20
SECTION 5. BUTTONHOLES
Buttonhole pag. 20
Corded buttonhole pag. 21
SECTION 6. CARE OF YOUR MACHINE
Cleaning the feed dog pag. 21
Cleaning the hook race area pag. 21
Replacing the light bulb pag. 22
Troubleshooting pag. 22
| 13
manuale inventa100 A4 24-07-2008 12:47 Pagina 13
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Termozeta 50001 Invent 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Termozeta 50001 Invent 100 in the language / languages: English, Italian, Spanish as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info