716817

Tepro 1088N - Natchez Manual

34
Zoom out
Zoom in
Previous page
1/44
Next page
34
t
Attention Risk of damage!
In order to prolong the service
life of the grill, make sure
that the hot charcoal and the
burning wood do not come into
direct contact with the walls of
the grill.
– Do not rub or scratch the external
housing of the hot grill during the initial
heating treatment.
• Prior to first use, the grill must be oiled
and then heated through for at least
3 hours to protect the housing from
heavy rust and to burn off production
residues.
Important: The grill should always
be stored in an oiled in condition and
covered up.
• Wash down the grill grate with warm,
soapy water. Then rinse it with clean
water and dry it off.
• Rub the external surfaces of the grill
with vegetable oil or use a vegetable oil
for spraying. Treat the charcoal grate
and the ash tray with vegetable oil.
• A tin can must be placed under the
grease runoff opening at all times. Place
an empty, open tin can (e.g. a beverage
can) into the grease tin holder.
• Follow the instructions for lighting the
grill. You can use charcoal or wood.
• Start with approx. 3.5 – 4 kg of charcoal.
This quantity should be sufficient for the
primary heating treatment.
• Pour sufficient lighter fluid over the
charcoal, in accordance with the
manufacturer specifications. Wait for
approx. 2-3 minutes with the cover
open, until the fluid has worked its way
into the coals. Alternatively, you can
use solid, commercial firelighters.
• Open the air vent of the small grill
chamber approx. 1.5 – 2.5 cm. Open
the exhaust flap of the smoke pipe up
to halfway.
• Light the charcoal with a long match.
Let the charcoal burn with the cover
open for as long as necessary until
a bright layer has formed (approx.
20 minutes). Caution! The lighter fluid
must be completely burned off before
the cover can be closed. Otherwise
flames from the lighter fluid can trigger
flashes or an explosion inside the grill
as soon as the cover is opened.
• When the charcoal is glowing strongly,
distribute the charcoal in the middle of
the charcoal grates.
• Then close the cover. Let the
temperature rise to approx. 120 °C.
Maintain this temperature range for
2 hours.
• Then increase the temperature to
approx. 175-200°C. This can be
achieved by opening the air vent of the
small grill chamber and the exhaust flap
of the smoke pipe further, and adding
additional charcoal or wood.
• Maintain this temperature for approx.
1 hour. Then let the grill cool down
completely.
• Important: From time to time this
treatment should be repeated in order
to maintain the condition of the grill.
• Attention: The temperature must
never exceed 200 °C. This is necessary
in order to make the inside ready for
barbecuing and to burn in the heat-
resistant paint on the outside. During
pre-firing, the grill chamber cover
should not be completely closed. Only
close it completely for a few minutes at
the end.
P140207-TEPRO-1088N_Natchez_20151214.indb 34 17/12/15 11:26 AM
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tepro 1088N - Natchez at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tepro 1088N - Natchez in the language / languages: English, German as an attachment in your email.

The manual is 10,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info