629388
16
Zoom out
Zoom in
Previous page
1/28
Next page
16
As with any other computer-controlled device, it is possible for the software in
your Vision system to “crash”. This may be caused by external influences, e.g. strong
electromagnetic interference, or previously undetected software errors.
If you think that your Vision system responds incorrectly or if it does not respond
at all, then we recommend restarting the microprocessor. This can be done in two
different ways and in any state of the system:
l If the fuse in the wiring harness is easily accessible, remove the fuse and
re-install it after a few seconds.
l RESET function:
To reset the Vision III control unit and the antenna, press all four buttons
(sat key , both arrow keys and the OK key ) simultaneously for
approx. 2 seconds until the revision number (e.g. „Rev: EU 1.02 2“) is
displayed.
In both cases described above, your Vision system will perform an internal restart.
If the system is open, it will now close. After restarting, the system is in rest mode
and can be started in the usual way using button .
Restarting the system
Main menu – Access to settings
The „Main menu“ is a selectable option of the general menu. Press in the option
Main menu to access the settings levels.
These levels provide the options „Settings“ (General information)“ and „Satellite
settings“. Please refer to the corresponding sections.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Oyster Vision III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Oyster Vision III in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Oyster Vision III

Ten Haaft Oyster Vision III User Manual - German - 28 pages

Ten Haaft Oyster Vision III User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info