773991
20
Zoom out
Zoom in
Previous page
1/24
Next page
Ice Maker Work Steps
The working steps of the ice maker are divided into three parts :
1. The automatic cleaning of the ice machine ( once, time 2 minutes )
When each ice maker starts, the automatic 2 minute cleaning program is
automatically carried out to clean the floating objects in the ice grid and the
tank. In 2 minutes the sink uninterrupted water, pump operation. The user can
hear the noise of the pump work flow from the top of the ice grid down into
the sink, and then overflow from the sink, from the drain outlet of the ice
storage bucket.
2. Ice ( cycle work, the longest 40 minutes )
After the completion of automatic cleaning, the pump will delay 45 seconds to
start, and then the ice began. When making ice, the water pump works
continuously from above the ice grid to the sink, and the water will slowly
become cold until it freezes. Ice thickness is measured by the ice thickness
detector during the ice making process. When the thickness of the test is
reached, the program will turn to the de-icing step. If the gap of the ice
thickness detector is too large, it will be forced into the de-icing program after
more than 40 minutes of ice making time.
3. De-icing ( cycle work, up to 4 minutes )
In the de-icing procedure, ice will be heated, ice and ice grid will be the
connection will be melted, when the ice due to weight and can not be attached
to the ice grid, it will fall off, complete a de-icing process.
When the ice falls, the water plate will be turned over, and then the water
retaining plate will be reset due to the dead weight, and then the machine
starts to make ice again. When the ice bucket is too much ice, the ice block can
not be reset, and the control chip is judged to be full of ice and temporarily
shut down until the water retaining plate is reset.
Fault self-diagnosis
1. Pump -- can directly observe whether there is water from the ice grid
up, if there is no pump failure.
2. Refrigeration--after 10 minutes of ice making, the water in the sink will
be significantly cooler, and you can feel the water temperature directly by
touching the ice grid or running water.
3. Influent-- one by one in the automatic cleaning process can be
observed in the tank overflow pipe constantly flowing into the ice storage
tank. In the process of ice making, you can put your hand into the water
tank to feel the amount of water, the normal situation accounts for more
than half of the sink.
-18-
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Temptech ICEQ210Z at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Temptech ICEQ210Z in the language / languages: English as an attachment in your email.

The manual is 5.86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info