649682
66
Zoom out
Zoom in
Previous page
1/164
Next page
- 66 -
CHANGE BATTERY Procedure
SUPPLIED VEHICLE
BATTERY BATTERY
REMOVAL CHANGE
- Press the “FUNCTION” button ( g. A.22) to select
the SUPPLY function ( g. A.12);
- if necessary or requested by the vehicle
manufacturer speci cations, customise the
voltage and/or current values as indicated above;
- press the “VOLT” button ( g. A.21) to select the
battery voltage ( g. A.1);
- connect the clamps to the relative vehicle battery
terminals;
- change the battery paying particular attention
not to disconnect the clamps from the vehicle
terminals so as not to lose the electronic settings.
3.7 START - STARTER AID (if foreseen)
START mode ( g. A.15), if foreseen, is available
for 12V batteries and supplies 70 A current as a
starter aid. If the battery is completely run down,
it is advisable to perform a precharge cycle before
proceeding.
FUNCTION SELECTION
3"
DISPLAY
3.7.1 Procedure
- Press and hold the “MODE” button ( g. A.23) for 3
seconds to select the “START” function;
- connect the vehicle battery terminal clamps (the
ashing message “Go” appears on the display ( g.
A.1);
- now start the vehicle; a 30 second timer will
engage and will appear on the display ( g. A.1),
at the end of which it will be possible to start the
engine again;
- on completing the selected process, disconnect
the power cable from the mains socket and
disconnect the clamps from the battery terminals.
FUNCTION EXIT
3.8 ALARMS
The alarms are displayed by a graph symbol ( g. A
.3) when there is a pole inversion, short circuit, low
or faulty battery.
The alarms will appear on the display ( g. A.2) and
have the following meanings:
AL1: Pole inversion and short circuit;
AL2: Battery voltage incompatible with operator’s
choice;
AL3: PULSE TRONIC charge: start of maximum
time Desulfation Phase 2 - battery not recoverable;
AL4: PULSE TRONIC charge: start of maximum
time Analyse Phase 3 - battery not recoverable;
AL5: PULSE TRONIC charge: start of maximum
time Main Charge Phase 4 - battery not recoverable;
AL6: PULSE TRONIC charge: start of maximum
time Verify Phase 6 - battery not recoverable;
AL7: PULSE TRONIC charge: start of maximum
time LCC - battery not recoverable;
AL8: PULSE TRONIC charge: start of maximum
time Pulse Tronic Phase 8 - battery not recoverable;
AL9: Short circuit in Supply / Diagnostic /
Equalization functions;
INFO ALARM
SHORT CIRCUIT
POLARITY REVERSAL
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin DOCTOR CHARGE 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin DOCTOR CHARGE 50 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 9,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info