649684

Telwin DOCTOR CHARGE 130 Manual

5
Zoom out
Zoom in
Previous page
1/272
Next page
- 5 -
EN
1. GENERAL SAFETY RULES FOR THE USE
- Avoid contact with battery acid. Should an operator
be sprayed or come into contact with the acid, rinse
the relative parts immediately under clean running
water. Continue to rinse the area until the physician
arrives.
- During the charge the battery produces explosive
gases, avoid the formation of ames and sparkes.
DO NOT SMOKE.
- Position the batteries to be charged in a well-
ventilated place.
- Protect the eyes. Always wear protective goggles
when using acid lead accumulators.
- Always wear suitable clothing. Never wear baggy
clothing or jewellery that can get caught up in
moving parts. During all operations, electrically
insulated protection clothing and non-slip boots
must be worn at all times. Persons with long hair
must tie it back and wear a hair net.
- Inexperience and untrained people should be
properly instructed before using the appliance.
- People (children included) whose physical, sensory
or mental capacities would prevent them from using
the appliance correctly must be supervised by a
person who is responsible for their safety while the
appliance is in use.
- Children must be supervised to ensure that they do
not play with the appliance.
- Use the battery charger only indoors and make sure
that you start it in airy places. DO NOT SET IN THE
RAIN OR SNOW.
- Disconnect the mains cable before connecting to or
disconnecting the charging cables from the battery.
- Do not connect or disconnect the clamps to or from
the battery with the battery charger operating.
- Never use the battery charger inside the car or in the
bonnet.
- Substitute the mains cable only with an original one.
- Do not use the battery charger to charge batteries
which are not rechargeable.
- Make sure the available power supply voltage
corresponds to that shown on the battery charger
rating plate.
- To prevent damaging the vehicle electronics,
scrupulously respect the warnings given by the
producer of the vehicle or the batteries used.
- This battery charger has components such as
switches and relays which can cause arcs or sparks.
Therefore when using it in a garage or in a similar
place set the battery charger in a suitable case.
- Repair or maintenance of the inside of the battery
charger can be executed only by skilled technicians.
- WARNING: ALWAYS DISCONNECT THE POWER
SUPPLY CABLE FROM THE MAINS BEFORE
CARRYING OUT ANY SIMPLE MAINTENANCE
OPERATION ON THE BATTERY CHARGER.
- The battery charger is protected from indirect
contact by an earth wire as indicated for class I
equipment. Make sure the power outlet is protected
by an earth connection.
- In models without this element, connect plugs
of appropriate capacity, not below the fuse value
indicated on the rating plate.
- Class A device:
This battery charger complies with the requirements
of the technical standard for products to be used
in industrial environments and for professional
purposes. No compliance with the electromagnetic
compatibility in domestic use buildings is guaranteed
and those connected directly to a low voltage power
supply network that furnishes buildings designated to
domestic use.
2. GENERAL DESCRIPTION
Battery charger indicated for charging WET, GEL, AGM,
PbCa lead batteries used by motorised vehicles (petrol and
diesel) and electric vehicles: automobiles, motor vehicles,
motorcycles, boats, etc. It is possible to charge 6V, 12V and
24V batteries; the 50 model also has a starter aid mode (for
vehicles with petrol and diesel engines only).
3. INSTALLATION
3.1 BATTERY CHARGER POSITION
When running, position the battery charger in a stable
position and make sure the air ow through the openings
which guarantee required ventilation is not blocked.
3.2 CONNECTION TO THE MAINS
- The battery charger must only be connected to a power
supply system with neutral conductor connected to
earth.
- Check that the mains voltage is the same as the battery
charger voltage indicated on the rating plate.
- The power line must have a protection system, such as
fuses or circuit breakers, that can support the maximum
apparatus absorption.
- Use the relative power cable when connecting to the
mains.
- Any power cable extensions must be of suitable section
size, never lower than that of the supplied power cable.
- It is always compulsory to connect the device to the
grounding system, using the yellow-green wire in the
power cable identied with the label (
), whilst the other
two wires must be connected to the phase and neutral
conductors on the mains power supply.
4. OPERATING DURING CHARGING
N.B.: Before charging, make sure the capacity (Ah)
of the battery to be charged is not lower than that
indicated on the battery charger rating plate (Cmin).
Follow the instructions scrupulously in the order given
below.
4.1 BATTERY PREPARATION
If the battery to be charged is the WET type, the procedure
is as follows:
- Remove the battery caps (if present), so that the gas
produced during charging can exit. Make sure the level
of electrolyte covers the battery plates; if they are not
covered, add distilled water until they are submerged by
5-10 mm.
ATTENTION! BE VERY CAREFUL WHILE
CARRYING OUT THIS OPERATION BECAUSE
THE ELECTROLYTE IS AN EXTREMELY
CORROSIVE ACID.
4.2 BATTERY CHARGER/BATTERY CONNECTION
- Check that the power cable plug has been disconnected
from the mains socket.
- Connect the red charging clamp to the positive battery
The documentation can be downloaded in PDF version from
the link: www.telwin.com/usermanual
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin DOCTOR CHARGE 130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin DOCTOR CHARGE 130 in the language / languages: All languages as an attachment in your email.

The manual is 148,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info