Manual Team rc 5 (page 16 of 64) (English, German, Dutch, French, Italian, Portuguese, Spanish)

380791

Zoom out

Zoom in

1/64



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

16 TEAM RC 5 - 091211

Assembly page 16/64

Fax +32 2 359 95 50

d) Citrus press set

 Make sure the appliance is unplugged, that the ON/OFF & speed switch (6) is in "0"

position and that the safety lid (20) is closed.

 Place the processor bowl (10) onto the shaft (fig. 2, page 6) and turn it clockwise until the

handle reaches the switch connector (8) (fig. 3, page 6).

 Place the support (18) on the shaft (9) (fig. 4, page 6).

 Place the strainer (22) on the bowl making sure its slot is in the direction of the bowl handle

(fig. 13, page 6).

 Put the cone (21) onto the shaft (fig. 14, page 6).

 Cut the fruits in two and press the fruit halves against the cone (inner side of the fruit on

the cone) (fig. 15, page 6).

 Plug in the appliance and turn the ON/OFF & speed switch to “1” to switch on the

appliance. For a punctual use, you can also use the pulse button (5), to do so turn the

ON/OFF & speed switch to “0”.

 When you use your appliance in an intensive way, it is necessary to make breaks of at

least 1 minute between every operation to let the motor cool down.

 Be careful not to exceed the maximum level indicated on the bowl and unplug the

appliance after use.

e) Mixing with the blender

Before using the blender (3), the processor bowl (10) has to be fitted into the base and the lid

properly locked. Do not put any accessory or food into the bowl.

 Unscrew the safety lid (20) to remove it.

 Open the lid of the blender, put the ingredients for mixing into the blender and add the

liquid. IT IS VERY IMPORTANT that the mixture does not go above the maximum level

indicated on the blender jug (fig. 17, page 6).

 Place the blender jug (3) on its connector switch (4) (fig. 18, page 6) and turn it clockwise

until the handle is oriented to the left and the jug is properly fixed to the motor unit (fig. 19,

page 6).

 Shut the lid with its cap (1) and screw it onto the blender. Make sure the assembly has

been done properly (the lid and the bowl have to be locked).

 Depending on the type of food, you can prepare up to 1.5 l with the blender.

 Plug in the appliance and turn the ON/OFF & speed switch to the desired speed or use the

pulse button depending on the preparation.

 Never use the processor and the blender simultaneously.

 Once the mixing is done, turn the ON/OFF & speed switch to “0” and unplug the

appliance. Wait until the blender has come to a complete stop before removing the jug.

 When you use your appliance in an intensive way, it is necessary to make breaks of at

least 1 minute between every operation to let the motor cool down.

 Caution: your appliance is not designed to mix hot preparations and the plastic bowl

could break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the

whole cool down to a temperature lower than about 60°C (tepid preparation) before

pouring it into the plastic bowl. In case the lid would come up in spite of the precautions

mentioned in section « Important safeguards », you can also empty part of the

preparation and mix it in several times.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Team rc 5 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Team rc 5

Team rc 5 Manual - German - 8 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info