487100

Team KR 2 Manual

17
Zoom out
Zoom in
Previous page
1/38
Next page
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don’t change the page
numbering. Keep the languages integrity.
17
Assembly page 17/38
Fax +32 2 359 95 50
Cut the potatoes, carrots, cucumbers etc… into pieces and place the ingredients into the funnel of
the bowl lid.
Use the pusher (7) to push food down the funnel. Never use your fingers or any other utensil.
Connect the appliance and turn the ON/OFF & speed control switch to “I” (slow speed) to start.
Depending on the type of food, you can prepare up to 1 kg within one and a half minute.
The operation can be carried out 5 times, with rest periods between each use.
Always turn the ON/OFF & speed control switch to “0” and unplug the appliance before emptying
the bowl as blades are very sharp.
Chopping / Blending / Kneading
Unplug the appliance.
With the processor bowl already into position, place the metal chopping blade (F) on the bowl
shaft as shown in figure . Then, put the ingredients in the bowl. To obtain a better result, cut
ingredients such as meat or vegetables first.
Place the bowl lid on the top of the processor bowl as described in the section «Use». Make sure
the shaft of the blade goes into the hole which is in the center of the lid.
Depending on the type of food, you can chop up to 1 kg of foodstuff, including vegetables, raw
or cooked meat, and raw or cooked fish.
For chopping, turn the ON/OFF & speed control switch to “II” (fast speed).
CAUTION: Do not try to chop products that are very hard (ice, sugar, coffee beans…).
Citrus Press Set
Unplug the appliance.
With the processor bowl already into position, place the citrus press shaft (16) on the bowl shaft
as shown in figure .
Place the strainer (15) on the processor bowl, then turn the handle until the lid locks into the bowl
lid locking slot. After this operation, one should not be able to lift the strainer.
Place the cone (14) into the hole which is in the strainer as shown in figure .
Cut the fruit in half, and put it on to the cone (the inner part against the cone).
Turn ON/OFF & speed control switch to “I” (slow speed) to start the appliance. For greater
control, you can use the pulse button (6) but only if you turn the ON/OFF speed control switch to
“0”. A light press will make the motor work slowly.
You can squeeze the two halves of the fruit for 30 seconds maximum each time. This operation
can be carried out 10 times, with rest periods between each use.
Be careful, when the cone does not rotate as it should, lightly release the pressure on the fruit
before pressing again. Do not insist too much on pressing as this could damage this accessory.
Be careful not to exceed the maximum level marked on the bowl and unplug after use.
Juice Extractor Set
Unplug the appliance.
Place the filter band (18) into the extractor (19). Make sure it is placed correctly.
Insert the collar (17) into the extractor to block the filter band.
With the processor bowl already into position, place the extractor assembly (17+18+19) on to the
bowl shaft as shown in figure .
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team KR 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team KR 2 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info