16
Do not clean Moveband with corrosive cleaning products.
Do not place Moveband in dishwashers, washing machines or dryers.
Do not place Moveband on or in heang devices, such as microwave ovens,
stoves, or radiators.
Do not expose Moveband to extreme temperatures. The recommended
temperature ranges from -20°C to 55°C.
Do not place Moveband close to re.
Do not dispose of Moveband in a re. This may cause the device to explode.
Prevent the USB connector from contacng water to avoid rust.
Do not crush, drop, or puncture your Moveband.
Never allow children to play with Moveband. Small components may present a
choking hazard to children.
You are not recommended to wear Moveband on the frequently-used hand.
IP (Ingress Protecon) Rang
Your device has been tested in a controlled environment and cered to be water-
and dust-resistant in specic situaons (meets requirements of classicaon IP67
as described by the internaonal standard IEC 60529 - Degrees of Protecon
provided by Enclosures [IP Code]; test condions: 15 - 35 °C, 86 - 106 kPa, 1
metre, 30 minutes). Despite this classicaon, your device is not impervious to
water damage in any situaon.
You may, for example, wear and use the device during exercise (exposure to sweat
is OK), in the rain, and while washing your hands with fresh water. However,
submerging your device is not recommended and the device is only protected
against low pressure water stream. Therefore, it’s not recommended to wear your
device while swimming or taking a shower.
When using your device, note that:
If the device is exposed to fresh water, dry it thoroughly with a clean, so cloth.
If the device is exposed to any liquid other than fresh water, such as salt water,
liquid chemicals, vinegar, alcohol, and liquid detergent, rinse the device with fresh
water immediately and dry it thoroughly with a clean, so cloth. Failure to rinse
the device in fresh water and dry it as instructed may cause it to suer from
operability or cosmec issues.
Dry your device before charging.
Do not submerge the device.
Do not expose the device to pressurised water or high velocity water, such as
water running from a tap, ocean waves, or waterfalls.