323659
14
Zoom out
Zoom in
Previous page
1/28
Next page
PROBLEM
-Drops of water appear
on the soleplate of the
iron when the steam
switch is pressed.
-Limescale is produced
by the soleplate of the
iron.
-Drops or patches of
water are left on the
ironed fabric.
-The iron is plugged in,
but the soleplate is cold
and the indicator light is
not lit up.
-There is no jet of steam
when the corresponding
switch is pressed.
-Steam escapes from the
boiler cap.
-It is difficult to unscrew
the safety cap.
-Some noise comes from
inside the boiler when it
has been switched on.
-The steam hose does
not reel in correctly.
POSSIBLE REASONS
-The iron is not hot
enough.
-The boiler is too full.
-The boiler is not in a
level position.
-There is too much
limescale inside the boiler.
-The ironing board is not
vented.
-The iron is not turned on.
-The iron temperature
regulator is set to
minimum.
-Low electricity supply.
-The boiler is empty.
-The boiler is not turned
on.
-The cap has not been
screwed on properly.
-There is still steam in the
boiler.
-There is still excess
steam left in the boiler
from the last time the iron
was used.
-The appliance is cold (the
noises are caused by the
dilation of the boiler).
-The steam hose is tangled
up in the steam hose reel.
SOLUTIONS
-Turn the iron temperature
regulator to steam (***).
-Remove water from the boiler.
-Put the appliance on a level
surface.
-Clean the boiler. See:
Preventing limescale in the
boiler.
-Change the ironing board for a
vented ironing board.
-Turn the iron on by pressing
the corresponding switch.
-Set the iron to the appropriate
temperature.
-Check the power cord and the
socket.
-Fill the boiler with water.
-Turn the boiler on by pressing
the corresponding switch.
-Let the iron cool down and
screw the cap on fully again.
-Press the steam switch until all
the steam has been released.
-Press the steam switch to
release the pressure.
-This will normally stop after a
few minutes.
- Straighten the steam hose.
If you cannot solve the problem This appliance complies with
or if a replacement power cord Low Voltage Directive
is required, contact an 73/23/EEC and with
authorised Technical Assistance Electromagnetic Compatibility
Service to avoid any possible Directive 89/336/EEC
danger.
hold the iron with one hand and
Vertical ironing (Fig.7) turn the steam hose reel in an
It's possible to iron your curtains anti-clockwise direction with the
while they are hanging, clothes other. (Fig.8)
on coat hangers etc. You can do 6. Press the power cord reel
this as follows: switch.
1. Select the maximum ironing 7. Close the lid.
temperature, turning the iron Note: Do not close the lid if the
temperature regulator in a iron is still hot.
clockwise direction. (Fig.2)
2. Activate the continuous steam Preventing limescale in the
control and iron from top to boiler
bottom. Less limescale is produced with
Important! For cotton and linen, the boiler's descaling system,
the sole plate of the iron should thanks to the exclusive features
be touching the fabric. For more of the stainless material it is
delicate fabrics, keep the sole made of. Nevertheless, it is
plate base at a distance of advisable to clean the boiler
several centimetres. every three months as follows:
1. Pour half a litre of water into
Storing the iron the boiler, shake and empty.
1. Turn the boiler and the iron Repeat this process two or three
off by pressing the times.
corresponding switches. (Fig.3) 2. If there is a large amount of
2. Disconnect from the mains. limescale in the boiler, use a
3. Leave the appliance to cool. descaling cleaning product for
4. Clean the iron and the rest of assistance. (Such as TAURUS
the appliance with a damp cloth. DECAL DESCALER).
Important: Do not submerge
the appliance in water or any Troubleshooting
other liquid, or put it under If you notice any irregularity,
running water. Do not use please consult the table below:
solvents or abrasive products to
clean it.
5. To reel in the steam hose
without the iron falling over,
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Taurus bravissimo20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Taurus bravissimo20 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info