EnglishNStainless steel soleplate (*) smoke when it is used for the during ironing. (Fig.4)
OSteam iron switchfirst time. This is caused by the 9. For a constant jet of steam,
Ironing StationPIron stand (*)greasing on the soleplate of the press the steam iron switch or
Bravissimo 20QContinuous steam controliron and will stop after a short the continuous steam control.
RIron temperature regulator- This appliance is for the use of period of time.(Fig.5)
Dear Customer,adults only. Keep out of 10 The water level indicator
Thank you for choosing a (*) Not available in all models.children's reach.Filling the boiler (Fig.1)light will light up when there is
TAURUS appliance.- Do not use this appliance for 1. The appliance must not be no more water left in the boiler.
The design, features and Safety warning and advice purposes other than those plugged into the mains.(Fig5)
technology of this appliance, as - Carefully read this instruction described in this booklet.2. Put the appliance on a flat and Do not use steam in thermostat
well as the strict quality controls booklet before use and keep for - Be particularly careful if the stable surface.positions * and ** since the sole Filling the boiler while ironing
used during manufacture, will further reference.appliance is used by or in the 3. Unscrew the safety cap, plate could drip water.(Fig.1)
provide full satisfaction for - Unpack the appliance vicinity of disabled people.turning anticlockwise, then fill 1. Turn off the boiler and the
many years.completely, making sure it is in - Do not leave the appliance the boiler with tap water. 5. Turn the iron and the boiler iron by pressing the
The packing materials used for good condition and full working unattended while it is plugged However, if the water is too hard on by pressing the corresponding switches. (Fig3.)
this appliance are part of a pick-order, since any factory defect or into the mains.(more than 12ºDH) we advise corresponding switches. The 2. Unplug the appliance from
up, sorting and recycling system transport damage is covered by - The ironing board must be the use of distilled water.relevant indicator lights will the mains.
(Green Point). If you wish to the TAURUS warranty.vented to allow the steam to 4. Close the boiler by turning the light up. (Fig. 3). DO NOT 3. Slowly unscrew the safety
discard them, please use the - This appliance is solely for pass through the garments. cap in a clockwise direction OPEN the safety cap from now cap, turning in an anti-clockwise
public containers provided for home use, not for industrial use.- The soleplate of the iron can until tight.on, because steam is being direction, so that any excess
each kind of material.- When filling the reservoir, the reach high temperatures. To generated in the boiler.steam left inside the boiler is
appliance must not be plugged avoid burns, do not touch it.Steam ironing6. Turn the steam control in a slowly released.
Description in. (Fig. 1).- Do not open the boiler's safety Before steam ironing, we advise clockwise direction to increase 4. Wait a few minutes to let the
AIron on/off switch- Check that the mains voltage cap if there is pressured steam filling the boiler up so that you the amount of steam emitted. To boiler cool down and very
BSteam on/off switchmatches the rated voltage on the inside.do not need to refill it again.reduce the amount of steam slowly pour in the water, using a
CIron indicator lightmanufacturer's plaque.- Do not close the lid while the 1. Unroll the cable to its full emitted, turn in the opposite jug.
DBoiler indicator light- The reservoir plug must be iron is switched on, or before it length and plug into the mains.direction. (Fig.3)5. Close the boiler by turning the
ESteam ready indicator light closed during operation.has cooled down after being 2. Open the lid.7. At the beginning of a session safety cap in a clockwise
FSafety cap- This appliance must be switched off.3. Take the iron and pull it out it is NOT advisable to direct the direction until tight.
GWater level indicator light connected to an electrical socket - The manufacturer is not till getting the hose maximum first jet of steam at the fabric to
HBoilerwith an earthing connection.responsible for any damage length for ironing.be ironed. Some drops of water, Dry ironing
ILid (*)-caused due to the misuse of the 4. By turning the temperature caused by thermal instability, 1. Plug the appliance into the
JCord wrapappliance.regulator, the temperature can could appear on the soleplate. mains and select the desired
KSteam controlbe adjusted according to the 8. Begin ironing when the steam temperature with the iron
LSteam hose reelSuggestions before startingkind of fabric to be ironed. ready indicator light is lit up. temperature control. Then press
MSteam hose support (*)- The iron may give off a little (Fig.2)This light will turn on and off the iron on/off switch.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Taurus bravissimo20 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Taurus bravissimo20 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.
The manual is 4,21 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
