587255
16
Zoom out
Zoom in
Previous page
1/68
Next page
Setup
Note: Use only DB25 cables specified by the manufacturer as "Analog" cables.
Many cables look the same on the outside.
The analog DB-25 pinout is pictured below:
Synchronization and Control
This section will deal with the physical connections needed in various synchronized
applications. For details about the appropriate software settings, please refer to Section
'Synchronization'(page 45).
MIDI
There are two MIDI connectors on the rear of the X-48. These are used for MIDI Machine
Control (MMC) and MIDI Time Code (MTC).
IN – This connector receives MTC, which the X-48 can chase, or MMC, which the X-48
can respond to. The front panel MIDI LED will illuminate when valid MIDI signals are
present at this connector.
OUT – This connector outputs MTC any time the transport is in motion. That MTC output
follows the frame rate and output options set for LTC output.
Time Code
There are two ¼” TRS connectors on the rear of the X-48, used for sending & receiving
time code (LTC). These connectors are balanced to allow for long cable runs with minimal
interference. Please refer to page 48-52 for details on time code options.
Footswitch
A normally-open, momentary footswitch may be connected to this ¼” TS connector for
hands free transport and recording operation. NOTE: To operate correctly, as footswitch
must be connected before the X-48 is powered on.
Remote (Sony 9-Pin)
This is also known as “P2” or “Sony P2” or “RS-422”. Various recording consoles and
video controllers support this protocol for transport control and track record enable. This
16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tascam X-48 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tascam X-48 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info