617896
48
Zoom out
Zoom in
Previous page
1/76
Next page
48 TASCAM DP-03SD
9 – Mixing down and mastering tracks
Mixing down tracks
Mixing down tracks is the process of adjusting the volumes and
stereo positions of each recorded track and mixing them into a
well-balanced stereo track.
Levels and balance
Use the TRACK 1-8 faders to adjust the relative balance of the
tracks. Then use the MASTER fader to adjust the overall level.
Watching the
L
and
R
meters on the display, adjust the level
until it is suitable.
If the volume is too loud, the sound will be distorted.
NOTE
The track meters on the display show the recorded signal
levels of the tracks. Therefore, these meters do not change
when the TRACK faders are adjusted.
TIP
You do not need to keep the entire song at the same volume.
For example, you could gradually increase the volume
during a guitar solo.
Stereo position (panning)
Use the PAN knobs of the tracks to adjust the stereo positions of
their signals.
Track EQ (equalizer)
Each track has a 2-band equalizer (EQ).
Set the track EQ using the EQ SETTING screen.
1 Press the EQ button to open the
EQ SETTING
screen.
2 Set the track EQ (equalizer).
The track equalizer has the following parameters.
GAIN FREQ
Hi
High-frequency gain
Setting range: ±12 dB
(Default value: 0.0 dB)
High-frequency value
Setting range: 1.7–18 kHz
(Default value: 5 kHz)
Lo
Low-frequency gain
Setting range: ±12 dB
(Default value: 0.0 dB)
Low-frequency value
Setting range: 32 Hz–1.6
kHz
(Default value: 350 Hz)
Use the REC button to select the track.
Use the EQ HIGH knob to adjust the
Hi
gain and the EQ
LOW knob to adjust the
Lo
gain.
Use the F3 (§) and F4 () buttons to select
Hi
or
Lo
, and
use the DATA wheel to set the
FREQ
value.
Press the F1 (
INPUT
) button to make
INPUT EQ
settings. (See “Using input EQ (equalizer)” on page 34.)
3 After making the setting, press the HOME button to return
to the Home Screen.
NOTE
When track EQ is applied to a track, the track is shown on
the Home Screen as in the illustration below.
TRACK EQ
is ON
Track EQ is used on all tracks in the example above.
Reverb
This unit has six types of reverb effects.
Adjust the level of the signal sent to the reverb effect from each
track by using their REVERB knobs.
NOTE
Both reverb and track EQ (equalization) can be used the
same time. The reverb is applied after the track EQ.
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tascam DP-03SD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tascam DP-03SD in the language / languages: English as an attachment in your email.

The manual is 6,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info