647166

Sygonix Touch IP65 Manual

26
Zoom out
Zoom in
Previous page
1/80
Next page
The home technology brand for the entire house. More information at www.sygonix.com
26
7. Installation and Connection
The connection cables must not be kinked or squashed. This can result
in malfunctions, short circuits and defects in the device.
Connection is only possible when powered down.
• The code lock can be installed on the wall or another surface via two open-
ings.
Use suitable screws and possibly dowels for screwing on. When drilling or
screwing on, observe that no cables or lines are damaged.
The scope of supply includes two special screws and a matching screwdriver
bit. The shape of the screw head offers additional protection from manipula-
tion attempts.
• If no light falls onto the brightness sensor at the rear, a voltage of 12 V/DC
is pending between the red and blue lines. This can be assessed, e.g., by an
alarm system to trigger a siren when there is any manipulation attempt at the
code lock.
Observe that direct connection of a consumer to the blue line is not permis-
sible. This would damage the code lock.
• Connect the connection cables accordingly. Wiring for the individual cables is
found in the above chapter.
The stabilised operating voltage is connected to the red (12 V/DC, Plus/+) and
black wires (GND/-).
• Depending on which door lock is used („Fail-Safe“ or „Fail-Secure“, see chap-
ter 7), either the orange or white cable must be used.
• Switch on the operating voltage. The left LED ashes alternatingly yellow and
red, the right one ashes green.
After a few seconds, the code lock emits 3 sound signals and the left LED
lights up red (the right, green, LED goes out). It is then ready for operation.
• For the rst function test, enter “3333” as the code.
A sound signal is emitted and the lock is activated for 5 seconds. During this
time, the right LED (2) lights up green.
This pre-programming can, of course be changed. See chapter 8.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sygonix Touch IP65 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sygonix Touch IP65 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info