664348
13
Zoom out
Zoom in
Previous page
1/20
Next page
Note:
a. For rst use, it is normal that a slight vibrating sound may occur from
the electrical pump inside the base unit for a few seconds when steam
ironing is started. It is because there is air inside the lter. It will stop when
the air inside the lter has been pumped out. If this abnomal condition
continues to happen for more than 60 seconds, please check whether
water tank and lter is assembled correctly.
b. When set at “NYLON” position, no steam is released since dry ironing
is most suitable.
c. When fabric setting is set at “POLYESTER” / “RAYON” / “COTTON”
“LINEN”, steam will automatically vary according to sole-plate
temperature. The pump will stop working and no steam released when the
sole-plate temperature becomes too low. It will resume once reheated
to the desired temperature.



1. Connect the appliance to a suitable socket outlet and lay handle down. Power
indicator light (red) “ ” on iron unit will light up indicating that the unit has been
connected to the power supply.
2. Set selection button to desired position according to fabric setting chart (page 08).
Blue indicator light on iron unit will blink slowly to indicate the unit being heated
up. When the blue indicator light changes to a steady light and an audible “Bi”
signal produced, the desired temperature has been reached. During use, blue
indicator light will cycle from blinking to a steady light and then from steady
mode to ON.
3. After use, put iron unit back onto the base unit again, turn selection button to
“ ” and then unplug the appliance from main socket.
Note:
When changing your temperature setting from higher setting to lower, you
should not start ironing immediately since it may cause burns to your fabrics.
Please wait till blue indicator light lights up steadily, and then start ironing.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Swan SI9032 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Swan SI9032 in the language / languages: English as an attachment in your email.

The manual is 2,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info