488889
79
Zoom out
Zoom in
Previous page
1/530
Next page
TIP: Changing Kernel and initrd Filenames
It is possible to use different lenames for Kernel and initrd images. This is
useful if you want to provide different operating systems from the same
boot server. However, you should be aware that only one dot is permitted
in the lenames that are provided by TFTP for the PXE boot.
An example /srv/tftpboot/pxelinux.cfg/default le follows. Adjust
the protocol prex for the repository to match your network setup and specify your
preferred method of connecting to the installer by adding the vnc and
vncpassword or the usessh and sshpassword options to the install entry.
The lines separated by \ must be entered as one continuous line without a line break
and without the \.
default harddisk
# default
label linux
kernel linux
append initrd=initrd ramdisk_size=65536 \
install=nfs://ip_instserver/path_to_repository/product/DVD1
# rescue
label rescue
kernel linux
append initrd=initrd ramdisk_size=65536 rescue=1
# bios test
label firmware
kernel linux
append initrd=biostest,initrd splash=silent install=exec:/bin/run_biostest
showopts
# memory test
label memtest
kernel memtest
# hard disk
label harddisk
localboot 0
implicit 0
display message
prompt 1
timeout 100
Remote Installation 61
79


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Suse openSUSE 12.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Suse openSUSE 12.2 in the language / languages: English as an attachment in your email.

The manual is 8,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Suse openSUSE 12.2

Suse openSUSE 12.2 Quick start guide - English - 284 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info