464692
38
Zoom out
Zoom in
Previous page
1/75
Next page
SRC-7000 User’s Manual
36
Tap soft button to start auto searching. When you see the
targeted device has been turned off, tap or press any button
immediately to stop auto searching. Then press
to test the
power key. If it can’t work, please go through step as below.
Tap or gently to figure out the correct remote code
(Code number as shown on the top middle position of the LCD.)
until the targeted device has been turned on again. Press the
power key or the hard key to test and to confirm the codes.
If the codes are not correct please repeat
steps and select “All”.
Repeat the
~ again to find the proper code for your target
device.
If you still can’t find the proper code for your device, please select
All” in the Brand item then tries to auto search the code again.
After the Pre-code auto search is finished the LCD will show a
“Search completely” message and an “OK” icon. Tap the “OK” to exit
the auto search. This means the SRC-7000 has already search the
defined area codes already. The codes might not include in the pre-
code database.
5. In this page, you will find an icon
which is the “Key Pad Entry”
function. You can also press the icon to enter the “Key Pad Entry”
function.
6. Key in the code number for your device directly. In this way, you are
able to save the time to load the corresponding codes. However,
each brand may have several remote codes. You may need to load
the remote codes several times to find the correct codes for your
device.
7. If they work, it means that you have found the correct remote codes.
Please press the
button to confirm your decision.
8. If you intend to setup another device code, please repeat step 3~7.
If you still can’t use Pre-code to load correct code for your device,
please use “Learning Function” on next section.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sunwave SRC-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sunwave SRC-7000 in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info