464692
21
Zoom out
Zoom in
Previous page
1/75
Next page
Chapter 2 Quick Start
19
2.3 Device Setting
SRC-7000 will automatically get through the setup mode when you
operate the SRC-7000 for the first time.
1. Select the targeted device you wish to set up. Please tap the target
device key in the Main Menu to enter “Setup device” menu. (ex. “TV”
device)
1. 2. 3.
* Pre-code: load pre-programmed IR code from the factory
default (no guarantee being able to control all brand
devices).
2. Press the
or buttons to choose “Yes” item and press
button for entering the operation mode.
3.
Choose the first letter of targeted device brand (ex. “S” on
behalf of Sony, Samsung…etc), and point the SRC-7000 at
the targeted device. After selecting “Brand” item, please
turn on your target device.
Tap soft button to start auto searching. When you see
the targeted device has been turned off, tap or press any
button immediately to stop auto searching. Then press
to test the power key. If it can’t work, please go through
step as below.
Tap or gently to figure out the correct remote
code (Code number as shown on the top middle position of
the LCD.) until the targeted device has been turned on
again. Press the power key or the hard key to test and to
confirm the codes.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sunwave SRC-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sunwave SRC-7000 in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info