464692
11
Zoom out
Zoom in
Previous page
1/75
Next page
Chapter 1 Introduction to the SRC-7000
9
1.5.2 Botton of SRC-7000
Figure 1-4: Rear view
1. IR port
This needs to be pointed to the IR
receiver of the targeted device.
2. Reset switch
You can reset the SRC-7000 when
the SRC-7000 does not work
properly or hangs up (freezes).
3. Rear label
The rear label marks the model
number and the brief specifications.
4. Buzzer opening
Beep tone signals are transmitted
through here.
5. Battery compartment
Contains the 3xAAA Alkaline
batteries or Ni-MH rechargeable
batteries.
6. Learning eye (P.37)
The SRC-7000 learns the IR codes
from the original device through
this learning eye. Simply point the
original device to SRC-7000this
learning eye 2~4 inch apart and
press corresponded key on the
original device, and save the
corresponding code into the SRC-
7000.
In this way, SRC-7000 will learn the
IR codes from your original device.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sunwave SRC-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sunwave SRC-7000 in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info