704206
24
Zoom out
Zoom in
Previous page
1/52
Next page
80-0067-00-MO-RevJ 2019-01-30 SunTech CT40 User Manual | 24
The timer will then count down the
seconds until the first reading.
After all measurements are taken
and averaged, results will display.
A long beep will sound to indicate
measurement is complete.
Example of SYS, DIA and HR* after
BP measurement in Single
Measurement Mode.
Example of SYS, DIA and HR* after
all measurements have been
averaged.
Example of SphygMode display with
cuff pressure at zero. P-set value is
default 160 mmHg.
*Note: Pulse rate source, whether BP or SpO2, can be selected at any time using the Advanced Configuration
Application. The default setting uses BP as HR source. If used outside of the United States, the device also can be
configured to measure MAP using the Configuration Application. If set up to measure MAP, the MAP and HR
measurements will alternate in 3-second intervals. NOTE: MAP is not available in the U.S.
Step 5: Record Results
When the measurement cycle is complete, values will be displayed for systolic and diastolic pressure, plus heart rate
if BP is selected as the pulse rate source. * Manually record, print and/or digitally save your measurements according
to your healthcare facility’s preferred process. To send results to an EMR or to the device memory, follow the steps in
Section 4.
Step 6: Prepare for New Patient
After all measurements have been recorded or captured, remove the cuff from the patient and clean it according to
your facility’s requirements. This disinfecting and storage step applies to BP cuffs as well as other optional
accessories whose use will be covered in the following sections.
Pressing the Memory Button will clear all patient and measurement data from the display, in addition to
saving the patient and measurement information in memory. It is recommended that the display is cleared before
taking readings on a new patient.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SunTech CT40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SunTech CT40 in the language / languages: English as an attachment in your email.

The manual is 2,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of SunTech CT40

SunTech CT40 User Manual - German - 49 pages

SunTech CT40 User Manual - Dutch - 52 pages

SunTech CT40 User Manual - French - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info