664820

Suntec Klimatronic ENERGIC plus 9.0 Manual

21
Zoom out
Zoom in
Previous page
1/192
Next page
21
The cold extract air has to be led out of the room via the air hose. This can be executed e.g. via a tilted
window, a door or wall aperture. Make sure that no cold outside air can enter the room. For effective
heating, we recommend our selection of various accessories which reduce or prevent entry of cold air into
the room.
Set the function to „Heating“. The settable temperature range is between 15°C and 25°C target
temperature. You can set this using the temperature control.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control
lamp has flashed for three minutes. Cooling effect may require a further 10 minutes. Further information is
available under the part „Troubleshooting“.
HEATING IN OUTDOOR OPERATION
The ENERGIC unit is outside the room to be heated. Outdoor operation is ideal for the transition period in
which outside temperatures do no fall below 7°C. (If the outside temperature should however fall below 7°C
continuously, we recommend indoor operation). Connect the air hose and the air outlet grid to the ENERGIC
unit as displayed in the illustration, the air hose connection piece and air outlet grid need to be exchanged.
Set the function to „Heating“. The settable temperature range is between 15°C and 25°C target
temperature. You can set this using the temperature control.
The air with high oxygen content heated by the ENERGIC unit is fed into the room via the air hose. This
can be executed e.g. via a tilted window, a door or wall aperture. Make sure that no cold outside air can
enter the room. For effective heating, we recommend our selection of various accessories which reduce or
prevent entry of cold air into the room.
Using the “Comfort Control- S Kit“ you can also control the ENERGIC unit from inside using the remote
control.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control
lamp has flashed for 3 minutes. Cooling effect may require a further 10 minutes. Further information is
available under the part „Troubleshooting“.
DEHUMIDIFICATION
Humidity is extracted from the air, collected in the water tank and discharged via the condensation water
outlet. Only air the room if the humidity of the outside air is below than in the inside room. Set the function
to “Dehumidity”.
The rubber plug of the condensation water outlet is removed and a drainage hose attached. To collect the
condensation water easily in a tank, a drainage hose is included in the scope of delivery which you can
connect to the upper condensation water outlet. Allow water to flow out continuously in order to achieve
higher dehumification capacity. In the dehumidify mode, you must not feed the room air outside with the
extract air hose.
Caution: In the dehumidify mode, separate setting of the ventilator is not provided, since the
lowest ventilation level is already preset to ensure efficient dehumidification of ambient air.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Suntec Klimatronic ENERGIC plus 9.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Suntec Klimatronic ENERGIC plus 9.0 in the language / languages: All languages as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info