Manual Sunrise Medical Quicky Breezy X2 (page 7 of 64) (English, Dutch, French, Italian, Spanish)

622356

Zoom out

Zoom in

1/64

CLASSIC 100, 160, 160XL 7

ENGLISH

One Hand Wheel Locks

Your wheelchair is equipped with

two sets of wheel locks, that ope-

rate from the left or the right side.

They are applied directly against

the tyres. To engage, press the

wheel-lock lever forward against

the stop (fig. 1). To release the

wheel, pull the lever back to the

original position.

Holding power will decrease with:

• Worn tyre tread

• Tyre pressure that is too low

• Wet tyres

• Improperly adjusted wheel locks.

The wheel locks have not been

designed to be used as brakes for

a moving wheelchair. The wheel

locks should therefore never be

used to brake a moving

wheelchair. Always use the hand-

rims for braking. Make sure that

the interval between the tyres and

wheel locks complies with given

specifications. To readjust, loosen

screw and set the appropriate interval.

Tighten screw (see the page on torque).

CAUTION:

After each adjustment of the rear wheels, check

the interval to the wheel locks and readjust if

necessary.

Mounting the wheel lock too close toward the

wheel, will result in a higher effort to operate.

This might cause the brake lever extension to

break! Leaning on to the brake lever extension

while transfering will cause the lever to break!

Splashing water from tyres might cause the

wheel lock to malfunction.

Footplates

The footplates can be flipped up to

facilitate getting in and getting out

of your wheelchair.

Lower Leg Length

By removing the screws (1), the

legrest can be adjusted to fit any

lower leg length. Loosen the

screws, set the tubing with legrest

in the desired position, and then

tighten the screws. (See the page

on torque).

A minimum interval of 2.5 centimetres from the

ground should always be maintained.

Options – Footplates

2,5 cm

Legrests and Latch

The legrest can be swung in,

underneath the seat sling, or out-

wards.

Fit your legrest by inserting it with

the footplate(s) pointing toward the

in/outside. Then rotate it toward

the inside until it locks into place.

To remove the legrest, pull the

lever (1), swing the footrest towards

the in or outside and lift to remove

it. Make sure that the legrest is

properly locked into place.

CAUTION:

The legrests should not be used to lift or to carry

the wheelchair.

Flip-up footrest (standard or with length

adjustment):

To elevate:

Pull the footrest upwards and adjust it to the desired

height. You will hear the footrest click into place.

To lower:

Lift the lower leg and press the release lever to

unlock the footrest. You may now lower the footrest.

As soon as you let go of the lever, the footrest will

lock into place.

CAUTION:

Keep hands clear of the adjustment mechanism

between the frame and the movable parts of the

footrest while elevating or lowering the footrest.

CAUTION:

Footrests are not to be used for lifting or carry-

ing the wheelchair.

Stump pad

The stump pad can be adjusted in all directions to

fit the users need.

1009/3/ST-000690634.EMS.2/Rev.D

Castors, Castor Plates, Forks

From time to time the wheelchair may veer slightly

to the right or left, or the castors may flutter. This

may be caused by the following:

• Forward and/or reverse wheel motion has not

been set properly.

• The castor angle has not been adjusted properly.

• Castor and/or rear wheel air pressure is incorrect;

wheels do not turn smoothly.

The wheelchair will not move in a straight line if the

castors have not been properly adjusted. Castors

should always be adjusted by an authorized dealer.

The castor plates must be readjusted, and the

wheel locks must be checked any time the rear

wheel position has been altered.

Options – Castor

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sunrise Medical Quicky Breezy X2 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sunrise Medical Quicky Breezy X2 Manual

Product: