Manual Sunrise Medical Quicky Breezy X2 (page 6 of 64) (English, Dutch, French, Italian, Spanish)

622356

Zoom out

Zoom in

1/64

6 CLASSIC 100, 160, 160XL

ENGLISH

Folding up

First remove the seat cushion and

back shell (comfort version only)

from the wheelchair and flip up the

(platform) footplate or the individu-

al footplates. Take hold of the sling

from underneath in the middle and

pull upwards. The wheelchair will

then fold up. To fold your

wheelchair until it is as small as

possible, e.g., to put into a car, you

can remove the footrests (depend-

ing on the model). For this purpo-

se, open the latch from the outside

and swing the footrest to the side.

Then the footrest only has to be

drawn out of the frame tubing.

Unfolding

Press down on the seat tubing (see

picture). Your wheelchair is then

unfolded. Now snap the seat

tubing into position in the seat

saddle. This can be facilitated by

slightly tipping your wheelchair. In

this way, the weight can be taken

off of one rear wheel so that the wheelchair can be

more easily unfolded. Be careful not to get your

fingers caught in the cross-tube assembly. Finally

put seat cushion and backshell on again.

Note: Make sure that the back shell snaps in

correctly.

Wheel Locks

Your wheelchair is equipped with

two wheel locks. They are applied

directly against the tyres. To enga-

ge, press both wheel-lock levers

forward against the stops (Fig. 282

and 283). To release the wheel, pull

the levers back to their original

positions.

Braking power will decrease with:

• Worn tyre tread

• Tyre pressure that is too low

• Wet tyres

• Improperly adjusted wheel locks.

The wheel locks have not been

designed to be used as brakes for

a moving wheelchair. The wheel

locks should therefore never be

used to brake a moving

wheelchair. Always use the hand-

rims for braking. Make sure that

the interval between the tyres and

wheel locks complies with given

specifications (Fig. 282 and 283).

To readjust, loosen screw (1) and

set the appropriate interval. Tigh-

ten screw (see the page on torque)

CAUTION:

After each adjustment of the

rear wheels, check the interval to the wheel

locks and readjust if necessary.

Handling Options – Brakes

Quick-Release Axles for Rear

Wheels

The rear wheels are equipped with

quick-release axles. The wheels

can thus be installed or removed

without using tools. To remove a

wheel, simply depress the quick-

release button on the axle (1) and

pull it out.

CAUTION:

Hold the quick-release button on

the axle depressed when insert-

ing the axle into the frame to mount the rear

wheels. Release the button to lock the wheel in

place. The quick-release button should snap

back to its original position.

Options – Step Tubes

Step Tubes

Step tubes are used by attendants

to tip a wheelchair over an

obstacle. Simply step on the tube

to push a wheelchair, for example,

over a curb or step.

3 mm

Extension for the wheel lock

Lever

The extension for the wheel lock

lever can be removed or folded

down. The longer lever helps to

minimize the effort needed to set

the wheel locks.

Caution:

Mounting the wheel lock too

close toward the wheel will

result in a higher effort to

operate. This might cause the

wheel lock extension lever to break!

Leaning onto the wheel lock extension lever

while transferring will cause the lever to break!

Splashing water from tyres might cause the

wheel lock to malfunction.

Drum Brakes

Drum brakes permit safe and

convenient braking for an atten-

dant. They can also be set with the

aid of a locking lever (1) to prevent

rolling. This lever must snap

audibly into place. Drum brakes

are not dependent on the aid of air

pressure inside the tyres. Your

wheelchair cannot be moved when

the drum brakes are set.

CAUTION:

Drum brakes should only be adjusted by

authorized dealers.

1009/3/ST-000690634.EMS.2/Rev.D

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sunrise Medical Quicky Breezy X2 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sunrise Medical Quicky Breezy X2 Manual

Product: