- 6 -
Use propane, butane, propane and butane mixture.
Maximum inlet pressure of regulator must to exceed 100 PSI.
The pressure regulator and hose assembly to be used must conform to local standard codes.
Use correct pressure regulators conform to local regulation in force and specification in page 7 of this manual.
The installation must conform to local codes, or in the absence of codes, with the standard for storage and
handling of liquid petroleum gases.
A dented, rested or damaged propane tank may be hazardous and should be checked by your tank supplier.
Never use a propane tank with a damaged valve connection.
The propane tank must be arranged to provide for vapor withdrawal from the operation cylinder.
Never connect an unregulated propane tank to the heater.
The rubber hose which connect the regulator and inlet should not longer than 60 cm
The rubber hose should be got CE approval, and heat resistant should be between-20℃ to 80℃
LEAKAGE TEST
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must
be performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to
the heater.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the OFF position.
• Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied
with a spray bottle, brush or rag.
• Soap bubbles will appear in case of a leak.
• Leakage test points. See pictures below.
• Turn the gas supply ON.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on and
recheck. Contact your dealer for assistance if bubbles continue to appear.
• Never leak test while smoking.
FUEL GAS ODOR
LP gas and natural gas have manmade odorants added specifically for detection of fuel gas leaks. If a gas leak occurs
