- 4 -
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
Installation and repair should be done by a qualified service person.
Improper installation, adjustment, alteration can cause personal injury or property damage.
Do not attempt to alter the unit in any manner.
This appliance must be installed and the gas cylinder stored in accordance with the regulation in force.
Do not move the appliance when in operation.
Shut off the valve at the gas cylinder or the regulator before moving the appliance.
The tubing or the flexible hose must be changed every year.
In case of violent wind particular attention must be taken against tilting of the appliance.
Do not store or use gasoline or other flammable vapors or liquids into the heater unit.
The whole gas system, hose regulator, pilot or burner should be inspected for leaks or damages before use.
All leak tests should be done with a soap solution. Never use an open flame to check for leaks.
Do not use the heater until all connections have been leak tested.
Turn off immediately the gas valve if smell of gas is detected.
Do not transport the heater while it’s operating.
Do not move the heater after it has been turned off until the temperature has cooled down.
Keep the ventilation opening of the cylinder enclosure free and clear of debris.
Do not paint radiant screen, control panel or top canopy reflector.
Control compartment, burner and circulation air passageways of the heater must be kept clean.
Frequent cleaning may be required as necessary.
The LP tank should be turned off when the heater is not in use.
Check the heater immediately if any of the following exists:
- The heater does not reach temperature.
- The burner makes popping noise during use (a slight noise is normal when the
burner is extinguished).
- Smell of gas in conjunction with extreme yellow tipping of the burner flames.
The LP regulator/hose assembly must be located out of pathways where people may trip over it or in area
where the hose will not subject to accidental damage.
Any guard or other protective device removed for servicing the heater must be replaced before operating the
heater.
Change the gas cylinder in a well ventilated area, away from any inflammation source.
Check that the regulator seal is fitted and that is in good condition.
Do not obstruct the ventilation holes of cylinder housing.
Adults and children should stay away from high temperature surfaces to avoid burns or clothing ignition.
Children should be carefully supervised when they are in the area of the heater.
Use may replace the rubber hose by himself and note the length of the hose is 60cm. And the hose must be
required by the national conditions.
LP Characteristics-Flammable, explosive, heavier than air-settles in low areas.
In its natural state, propane has no odor. For your safety, an odorant is added that smells like rotten cabbage.
Contact with liquid LP can cause freeze burns to skin.
This heater is shipped from the factory for Propane, Butane and their mixture (commonly called LPG) use only
Use only 10kg(Dia. can not exceed 31cm & Height can not exceed 66cm) LP gas cylinders conforms to local
regulation in force (same as commonly used on gas grills) with safety valves.
When heater is not in use, turn Control Valve OFF. Close the valve of the gas cylinder or the regulator after use.
The use of this appliance in enclosed areas can be dangerous and is “PROHIBITED”
